Water hardness in Marysville, OH

Water in Marysville is very hard, with a median of 326 mg/L (19 grains per gallon) across 86 monitoring sites within 10 miles.

18% harder than the Ohio median (276 mg/L) 26th hardest of 183 Ohio towns Population 28,423
326mg/L
19 grains per gallon
Very hard

Marysville tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 326 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 19 gpg (18.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites86
Lab samples819
Sample years2000–2024
Middle 50% of sites277–362 mg/L
Groundwater (wells, springs)728 mg/L · 2 sites
Surface water (rivers, lakes)322 mg/L · 84 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Marysville

Prefilled with Marysville's measured local hardness of 326 mg/L (19.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Marysville tap water

Marysville City PWS is the main public water system for Marysville. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken May 2023 – Mar 2026. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Marysville

Water systemPFAS detectedHighest PFOA / PFOSTested
Del-Co Water Company, INC.
serves over 10,000 people
PFBA, PFHxA, PFPeA +2 more 4.2 / ND ppt Jul 2023 – Apr 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Marysville

Marysville City PWS reported 11,570 service lines (the pipes connecting homes to the water main) in its inventory. 23 are lead and 8 are galvanized lines that must be replaced, and 738 are still of unknown material.

23lead (<1%)
8galvanized requiring replacement
738unknown material (6%)
10,801not lead (93%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Marysville City PWS whether your address is on its list.

Other water systems serving parts of Marysville

Water systemService linesTotal
Del-Co Water Company, INC.9 lead · 19 galvanized · 14,186 unknown56,197

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Marysville drinking water violations

EPA records show no health-based violations for Marysville City PWS since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Marysville

Water systemHealth-based violationsMonitoring/reporting
Del-Co Water Company, INC.None0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Marysville

SiteTypeDistanceMedianSamplesYears
TOWN RUN AT MARYSVILLE @ WALNUT ST. (UPPER CROSSING)
Division of Surface water (Ohio) (State)
River/Stream 0.3 mi231 mg/L12000
TOWN RUN AT MARYSVILLE @ WALNUT ST. (LOWER CROSSING)
Division of Surface water (Ohio) (State)
River/Stream 0.3 mi413 mg/L42012
TOWN RUN AT MARYSVILLE @ 8TH ST.
Division of Surface water (Ohio) (State)
River/Stream 0.6 mi267 mg/L12000
TOWN RUN AT MARYSVILLE @ 5TH STREET, DST. CULVERT
Division of Surface water (Ohio) (State)
River/Stream 0.6 mi274 mg/L72012
TOWN RUN AT MARYSVILLE @ MOUTH
Division of Surface water (Ohio) (State)
River/Stream 0.8 mi246 mg/L12000
MILL CREEK AT MARYSVILLE @ ST. RT. 4 (MAIN ST.)
Division of Surface water (Ohio) (State)
River/Stream 0.9 mi271 mg/L52012

Water hardness in towns near Marysville

TownDistanceMedianClass
Dublin14 mi 300 mg/LVery hard
Powell15 mi 269 mg/LVery hard
Delaware16 mi 305 mg/LVery hard
Hilliard17 mi 280 mg/LVery hard
Worthington20 mi 237 mg/LVery hard
Upper Arlington21 mi 240 mg/LVery hard
Urbana22 mi 365 mg/LVery hard
Bellefontaine23 mi 370 mg/LVery hard
London24 mi 342 mg/LVery hard
Westerville25 mi 260 mg/LVery hard

Union County

Marysville is in Union County, where the median is 333 mg/L (very hard) across 98 sites.

See all of Union County →

Ohio

The statewide median is 276 mg/L (very hard) from 6,849 sites.

Ohio hardness map →

Marysville, OH water: common questions

Do I need a water softener in Marysville?

Very likely. Water measured around Marysville is 19 gpg (326 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 33,000 grains.Size it for your household →

Who supplies Marysville's drinking water?

The main public water system serving Marysville in EPA records is Marysville City PWS. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Marysville?

It depends on what you want to remove. In Marysville, the system reports 23 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next