Water hardness in Hilliard, OH

Water in Hilliard is very hard, with a median of 280 mg/L (16.3 grains per gallon) across 87 monitoring sites within 10 miles.

about the same as the Ohio median (276 mg/L) 78th hardest of 183 Ohio towns Population 37,262
280mg/L
16.3 grains per gallon
Very hard

Hilliard tap water at a glance

  • HardnessVery hard (280 mg/L, 16.3 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 280 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 16.3 gpg (15.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites87
Lab samples1,096
Sample years2000–2024
Middle 50% of sites226–354 mg/L
Groundwater (wells, springs)486 mg/L · 3 sites
Surface water (rivers, lakes)276 mg/L · 84 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Hilliard

Prefilled with Hilliard's measured local hardness of 280 mg/L (16.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Hilliard tap water

Hilliard is served by more than one water system. These systems supply ZIP codes in Hilliard and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Hilliard

Water systemPFAS detectedHighest PFOA / PFOSTested
Columbus Public Water System
serves over 10,000 people
PFHxA, PFBA, PFPeA +3 more 5.3 / ND ppt Feb 2024 – Nov 2024
Del-Co Water Company, INC.
serves over 10,000 people
PFBA, PFHxA, PFPeA +2 more 4.2 / ND ppt Jul 2023 – Apr 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Hilliard

Hilliard is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Hilliard

Water systemService linesTotal
Columbus Public Water System25,155 lead · 8,093 galvanized · 65,266 unknown288,462
Del-Co Water Company, INC.9 lead · 19 galvanized · 14,186 unknown56,197

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Hilliard drinking water violations

Hilliard is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Hilliard

Water systemHealth-based violationsMonitoring/reporting
Columbus Public Water System10
Del-Co Water Company, INC.None0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Hilliard

SiteTypeDistanceMedianSamplesYears
CLOVER GROFF RUN AT HILLIARD, DST. SCIOTO-DARBY CREEK RD.
Division of Surface water (Ohio) (State)
River/Stream 1.1 mi224 mg/L62014
CLOVER GROFF RUN UPST. GOLF PATH, UPST. HERITAGE LAKES
Division of Surface water (Ohio) (State)
River/Stream 1.1 mi224 mg/L62014
CLOVER GROFF RUN @ SHOAL CREEK LANE, BRIDGE IN GOLF COURSE
Division of Surface water (Ohio) (State)
River/Stream 1.2 mi223 mg/L62014
CLOVER GROFF RUN AT HILLIARD @ FRANKS PARK
Division of Surface water (Ohio) (State)
River/Stream 1.5 mi222 mg/L62014
CLOVER GROFF RUN @ PARK ADJ. FRAZELL RD.
Division of Surface water (Ohio) (State)
River/Stream 2.1 mi228 mg/L62014
HAMILTON RUN AT HILLIARD @ BROCTON RD.
Division of Surface water (Ohio) (State)
River/Stream 2.2 mi214 mg/L62014

Water hardness in towns near Hilliard

TownDistanceMedianClass
Upper Arlington5 mi 240 mg/LVery hard
Dublin5 mi 300 mg/LVery hard
Worthington8 mi 237 mg/LVery hard
Columbus10 mi 115 mg/LModerately hard
Powell10 mi 269 mg/LVery hard
Grove City11 mi 325 mg/LVery hard
Bexley13 mi 276 mg/LVery hard
Westerville14 mi 260 mg/LVery hard
Gahanna15 mi 260 mg/LVery hard
Whitehall15 mi 276 mg/LVery hard

Franklin County

Hilliard is in Franklin County, where the median is 277 mg/L (very hard) across 175 sites.

See all of Franklin County →

Ohio

The statewide median is 276 mg/L (very hard) from 6,849 sites.

Ohio hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next