Water hardness in Seaford, NY

Water in Seaford is soft, with a median of 50 mg/L (2.9 grains per gallon) across 23 monitoring sites within 10 miles.

35% softer than the New York median (77 mg/L) 100th hardest of 193 New York towns Population 15,294 (2010)
50mg/L
2.9 grains per gallon
Soft

Seaford tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 50 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 2.9 gpg (2.8 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites23
Lab samples68
Sample years2000–2023
Middle 50% of sites17–58 mg/L
Groundwater (wells, springs)29 mg/L · 16 sites
Surface water (rivers, lakes)53 mg/L · 7 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Seaford

Prefilled with Seaford's measured local hardness of 50 mg/L (2.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Seaford tap water

Seaford is served by more than one water system. These systems supply ZIP codes in Seaford and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Seaford

Water systemPFAS detectedHighest PFOA / PFOSTested
New York American Water - Merrick
serves over 10,000 people
None detected — Mar 2023 – Jul 2025
South Farmingdale WD
serves over 10,000 people
None detected — Jun 2023 – Jul 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Seaford

Seaford is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Seaford

Water systemService linesTotal
Liberty Utilities New York - Merrick32 lead · 16 galvanized · 253 unknown45,999
South Farmingdale WD2 lead · 4 galvanized · 325 unknown12,664

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Seaford drinking water violations

Seaford is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Seaford

Water systemHealth-based violationsMonitoring/reporting
New York American Water - Merrick30
South Farmingdale WDNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Seaford

SiteTypeDistanceMedianSamplesYears
N 6866. 1
USGS New York Water Science Center
Well 1.2 mi32 mg/L12016
BELLMORE CREEK NEAR BELLMORE NY
USGS New York Water Science Center
Stream 1.5 mi56 mg/L42000–2001
MASSAPEQUA CREEK AT MASSAPEQUA, NY 309580
USGS New York Water Science Center
Stream 1.7 mi53 mg/L12000
MASSAPEQUA CREEK IN MASSAPEQUA
NYS Dept. of EnCon, Division of Water
River/Stream 1.9 mi53 mg/L102004
MASSAPEQUA CREEK AT MASSAPEQUA NY
USGS New York Water Science Center
Stream 2.5 mi51 mg/L42000–2001
CARMAN CREEK AT AMITYVILLE NY
USGS New York Water Science Center
Stream 3.1 mi68 mg/L42000–2001

Water hardness in towns near Seaford

TownDistanceMedianClass
Wantagh1 mi 50 mg/LSoft
Massapequa1 mi 50 mg/LSoft
Bellmore2 mi 50 mg/LSoft
North Wantagh2 mi 47 mg/LSoft
Massapequa Park2 mi 49 mg/LSoft
North Massapequa3 mi 49 mg/LSoft
North Bellmore3 mi 38 mg/LSoft
East Massapequa3 mi 47 mg/LSoft
Merrick3 mi 50 mg/LSoft
North Merrick4 mi 44 mg/LSoft

Nassau County

Seaford is in Nassau County, where the median is 50 mg/L (soft) across 47 sites.

See all of Nassau County →

New York

The statewide median is 77 mg/L (moderately hard) from 2,847 sites.

New York hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next