Water hardness in Revere, MA
Water in Revere is moderately hard, with a median of 93 mg/L (5.4 grains per gallon) across 15 monitoring sites within 10 miles.
Revere tap water at a glance
- HardnessModerately hard (93 mg/L, 5.4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 93 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.4 gpg (5.2 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Revere
Prefilled with Revere's measured local hardness of 93 mg/L (5.4 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Revere tap water
Revere Water Division (Mwra) is the main public water system for Revere. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jan 2023 – Oct 2023. 1 PFAS was detected.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| 6:2 FTS 6:2 fluorotelomer sulfonic acid | 6.2 ppt | 1 of 4 samples | — |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Revere
Revere Water Division (Mwra) has not yet reported its service line inventory to EPA (as of the first quarter of 2026). Ask the utility whether your home's service line has been identified.
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Revere drinking water violations
EPA records show no health-based violations for Revere Water Division (Mwra) since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Revere
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| SAUGUS RIVER AT SAUGUS IRONWORKS AT SAUGUS, MA USGS Massachusetts Water Science Center | Stream | 3.5 mi | 92 mg/L | 37 | 2000–2016 |
| New Charles River Dam US EPA Region 1 | River/Stream | 5.3 mi | 145 mg/L | 6 | 2003–2004 |
| Old Charles River Dam US EPA Region 1 | River/Stream | 5.7 mi | 128 mg/L | 16 | 2003–2004 |
| Community Boating Area US EPA Region 1 | River/Stream | 6 mi | 132 mg/L | 6 | 2003–2004 |
| Longfellow Bridge - upstream US EPA Region 1 | River/Stream | 6.2 mi | 122 mg/L | 18 | 2003–2004 |
| Charles River off the Esplanade US EPA Region 1 | River/Stream | 6.6 mi | 129 mg/L | 7 | 2003–2004 |
Water hardness in towns near Revere
| Town | Distance | Median | Class |
|---|---|---|---|
| Chelsea | 3 mi | 88 mg/L | Moderately hard |
| Winthrop Town | 3 mi | 109 mg/L | Moderately hard |
| Everett | 3 mi | 90 mg/L | Moderately hard |
| Saugus | 3 mi | 90 mg/L | Moderately hard |
| Malden | 4 mi | 83 mg/L | Moderately hard |
| Lynn | 4 mi | 121 mg/L | Hard |
| Melrose | 4 mi | 83 mg/L | Moderately hard |
| Boston | 6 mi | 16 mg/L | Soft |
| Swampscott | 6 mi | 107 mg/L | Moderately hard |
| Somerville | 6 mi | 82 mg/L | Moderately hard |
Suffolk County
Revere is in Suffolk County, where the median is 128 mg/L (hard) across 7 sites.
See all of Suffolk County →Revere, MA water: common questions
Do I need a water softener in Revere?
Probably not. Water measured around Revere is 5.4 gpg (93 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 10,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →
Who supplies Revere's drinking water?
The main public water system serving Revere in EPA records is Revere Water Division (Mwra). Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Revere?
It depends on what you want to remove. In Revere, EPA testing found 6:2 FTS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 1 PFAS in Revere's main water system.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.