Water hardness in Marblehead, MA

Water in Marblehead is moderately hard, with a median of 92 mg/L (5.4 grains per gallon) across 3 monitoring sites within 10 miles.

74% harder than the Massachusetts median (53 mg/L) 13th hardest of 88 Massachusetts towns Population 19,808 (2010)
92mg/L
5.4 grains per gallon
Moderately hard

Marblehead tap water at a glance

  • HardnessModerately hard (92 mg/L, 5.4 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 92 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.4 gpg (5.2 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites3
Lab samples41
Sample years2000–2019
Middle 50% of sites58–107 mg/L
Groundwater (wells, springs)73 mg/L · 2 sites
Surface water (rivers, lakes)92 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Marblehead

Prefilled with Marblehead's measured local hardness of 92 mg/L (5.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Marblehead tap water

Marblehead Water Dept. (Mwra) is the main public water system for Marblehead. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jan 2025 – Oct 2025. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Marblehead

Marblehead Water Dept. (Mwra) has not yet reported its service line inventory to EPA (as of the first quarter of 2026). Ask the utility whether your home's service line has been identified.

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Marblehead drinking water violations

EPA records show no health-based violations for Marblehead Water Dept. (Mwra) since 2016.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Marblehead

SiteTypeDistanceMedianSamplesYears
MA-HCW 208
USGS New Hampshire Water Science Center
Well 7.5 mi121 mg/L12000
MA-EXW 11
USGS New Hampshire Water Science Center
Well 8.8 mi24 mg/L32001–2019
SAUGUS RIVER AT SAUGUS IRONWORKS AT SAUGUS, MA
USGS Massachusetts Water Science Center
Stream 8.9 mi92 mg/L372000–2016

Water hardness in towns near Marblehead

TownDistanceMedianClass
Salem3 mi 92 mg/LModerately hard
Swampscott3 mi 107 mg/LModerately hard
Beverly4 mi 48 mg/LSoft
Lynn7 mi 121 mg/LHard
Peabody7 mi 102 mg/LModerately hard
Danvers8 mi 111 mg/LModerately hard
Saugus9 mi 90 mg/LModerately hard
Revere9 mi 93 mg/LModerately hard
Lynnfield11 mi 87 mg/LModerately hard
Winthrop Town11 mi 109 mg/LModerately hard

Essex County

Marblehead is in Essex County, where the median is 83 mg/L (moderately hard) across 15 sites.

See all of Essex County →

Massachusetts

The statewide median is 53 mg/L (soft) from 321 sites.

Massachusetts hardness map →

Marblehead, MA water: common questions

Do I need a water softener in Marblehead?

Probably not. Water measured around Marblehead is 5.4 gpg (92 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 10,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Marblehead's drinking water?

The main public water system serving Marblehead in EPA records is Marblehead Water Dept. (Mwra). Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Marblehead?

Not for anything in EPA's records: no PFAS found in EPA testing and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next