Water hardness in Belmont, MA

Water in Belmont is moderately hard, with a median of 82 mg/L (4.8 grains per gallon) across 34 monitoring sites within 10 miles.

55% harder than the Massachusetts median (53 mg/L) 32nd hardest of 88 Massachusetts towns Population 24,729 (2010)
82mg/L
4.8 grains per gallon
Moderately hard

Belmont tap water at a glance

  • HardnessModerately hard (82 mg/L, 4.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 82 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.8 gpg (4.6 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites34
Lab samples1,186
Sample years2000–2023
Middle 50% of sites70–107 mg/L
Groundwater (wells, springs)83 mg/L · 4 sites
Surface water (rivers, lakes)80 mg/L · 30 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Belmont

Prefilled with Belmont's measured local hardness of 82 mg/L (4.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Belmont tap water

Belmont Water Dept. (Mwra) is the main public water system for Belmont. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jan 2023 – Oct 2023. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Belmont

Water systemPFAS detectedHighest PFOA / PFOSTested
Cambridge Water Department
serves over 10,000 people
PFOA, PFPeA, PFHxA 4.8 / ND ppt Sep 2023 – Jun 2024
Watertown Water Dept. (Mwra)
serves over 10,000 people
None detected — Jan 2024 – Oct 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Belmont

Belmont Water Dept. (Mwra) has not yet reported its service line inventory to EPA (as of the first quarter of 2026). Ask the utility whether your home's service line has been identified.

Other water systems serving parts of Belmont

Water systemService linesTotal
Cambridge Water DepartmentNot reported—
Watertown Water Dept. (Mwra)Not reported—

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Belmont drinking water violations

EPA records show no health-based violations for Belmont Water Dept. (Mwra) since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Belmont

Water systemHealth-based violationsMonitoring/reporting
Cambridge Water DepartmentNone31
Watertown Water Dept. (Mwra)None1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Belmont

SiteTypeDistanceMedianSamplesYears
Watertown Dam - upstream
US EPA Region 1
River/Stream 2.1 mi69 mg/L162003–2004
CHARLES RIVER ABOVE WATERTOWN DAM AT WATERTOWN, MA
USGS Massachusetts Water Science Center
Stream 2.2 mi53 mg/L332000–2001
Daly Field - south bank
US EPA Region 1
River/Stream 2.5 mi75 mg/L72003–2004
Herter East Park - south bank
US EPA Region 1
River/Stream 3 mi77 mg/L62003–2004
ABERJONA RIVER AT WINCHESTER, MA
USGS Massachusetts Water Science Center
Stream 4.2 mi93 mg/L532000–2001
CAMBRIDGE RES., UNNAMED TRIB 3, NR LEXINGTON, MA
USGS Massachusetts Water Science Center
Stream 4.3 mi98 mg/L1212012–2023

Water hardness in towns near Belmont

TownDistanceMedianClass
Watertown Town2 mi 81 mg/LModerately hard
Arlington2 mi 82 mg/LModerately hard
Waltham3 mi 80 mg/LModerately hard
Cambridge3 mi 82 mg/LModerately hard
Somerville4 mi 82 mg/LModerately hard
Medford4 mi 83 mg/LModerately hard
Lexington4 mi 80 mg/LModerately hard
Winchester4 mi 87 mg/LModerately hard
Newton5 mi 81 mg/LModerately hard
Brookline5 mi 81 mg/LModerately hard

Middlesex County

Belmont is in Middlesex County, where the median is 76 mg/L (moderately hard) across 51 sites.

See all of Middlesex County →

Massachusetts

The statewide median is 53 mg/L (soft) from 321 sites.

Massachusetts hardness map →

Belmont, MA water: common questions

Do I need a water softener in Belmont?

Probably not. Water measured around Belmont is 4.8 gpg (82 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 9,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Belmont's drinking water?

The main public water system serving Belmont in EPA records is Belmont Water Dept. (Mwra). Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Belmont?

Not for anything in EPA's records: no PFAS found in EPA testing and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next