Water hardness in Seabrook, MD

Water in Seabrook is moderately hard, with a median of 60 mg/L (3.5 grains per gallon) across 19 monitoring sites within 10 miles.

about the same as the Maryland median (56 mg/L) 81st hardest of 121 Maryland towns Population 17,287 (2010)
60mg/L
3.5 grains per gallon
Moderately hard

Seabrook tap water at a glance

  • HardnessModerately hard (60 mg/L, 3.5 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 60 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 3.5 gpg (3.4 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites19
Lab samples117
Sample years2000–2023
Middle 50% of sites16–103 mg/L
Groundwater (wells, springs)14 mg/L · 8 sites
Surface water (rivers, lakes)74 mg/L · 11 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Seabrook

Prefilled with Seabrook's measured local hardness of 60 mg/L (3.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Seabrook tap water

Seabrook is served by more than one water system. These systems supply ZIP codes in Seabrook and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Seabrook

Water systemPFAS detectedHighest PFOA / PFOSTested
Washington Suburban Sanitary Commission
serves over 10,000 people
PFPeA, PFHxA — Mar 2023 – Jun 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Seabrook

Seabrook is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Seabrook

Water systemService linesTotal
Washington Suburban Sanitary Commission8 lead · 1,277 galvanized · 57,121 unknown58,406

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Seabrook drinking water violations

Seabrook is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Seabrook

Water systemHealth-based violationsMonitoring/reporting
Washington Suburban Sanitary CommissionNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Seabrook

SiteTypeDistanceMedianSamplesYears
PG Cd 25
USGS Maryland Water Science Center
Well 0.9 mi5 mg/L12016
BALD MILL BRANCH AT LANHAM, MD
USGS Maryland Water Science Center
Stream 1.8 mi103 mg/L12000
HORSEPEN BRANCH AT BOWIE, MD
USGS Maryland Water Science Center
Stream 3.5 mi74 mg/L12000
LOTTSFORD BRANCH NEAR GLENARDEN, MD
USGS Maryland Water Science Center
Stream 3.7 mi57 mg/L12000
NORTHEAST BRANCH ANACOSTIA RIVER AT RIVERDALE, MD
USGS Maryland Water Science Center
Stream 4.3 mi60 mg/L12007
PG Be 38
USGS Maryland Water Science Center
Well 4.7 mi7 mg/L12003

Water hardness in towns near Seabrook

TownDistanceMedianClass
Lanham2 mi 60 mg/LModerately hard
New Carrollton2 mi 60 mg/LModerately hard
Greenbelt2 mi 60 mg/LModerately hard
Glenn Dale3 mi 53 mg/LSoft
East Riverdale4 mi 67 mg/LModerately hard
Mitchellville4 mi 67 mg/LModerately hard
Landover4 mi 60 mg/LModerately hard
College Park5 mi 103 mg/LModerately hard
Summerfield5 mi 67 mg/LModerately hard
Beltsville5 mi 54 mg/LSoft

Prince George's County

Seabrook is in Prince George's County, where the median is 60 mg/L (moderately hard) across 27 sites.

See all of Prince George's County →

Maryland

The statewide median is 56 mg/L (soft) from 1,412 sites.

Maryland hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next