Water hardness in Manhattan, IL

Water in Manhattan is very hard, with a median of 237 mg/L (13.9 grains per gallon) across 12 monitoring sites within 10 miles.

19% softer than the Illinois median (293 mg/L) 183rd hardest of 225 Illinois towns Population 10,547
237mg/L
13.9 grains per gallon
Very hard

Manhattan tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 237 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 13.9 gpg (13.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites12
Lab samples89
Sample years2000–2016
Middle 50% of sites222–263 mg/L
Surface water (rivers, lakes)237 mg/L · 12 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Manhattan

Prefilled with Manhattan's measured local hardness of 237 mg/L (13.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Manhattan tap water

The City of Manhattan water system is the main public water system for Manhattan. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jun 2025 – Dec 2025. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Manhattan

The City of Manhattan water system reported 3,567 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
3,567not lead (100%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Manhattan drinking water violations

EPA records show no health-based violations for the City of Manhattan water system since 2016. It also had 30 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Manhattan

SiteTypeDistanceMedianSamplesYears
JACKSON CREEK AT MANHATTAN RD NR ELWOOD, IL
USGS Illinois Water Science Center
Stream 6 mi268 mg/L12000
HICKORY CREEK AT SCHMUHL RD NR NEW LENOX, IL
USGS Illinois Water Science Center
Stream 7.3 mi236 mg/L12000
SUGAR RUN AT MILLS ROAD AT JOLIET, IL
USGS Illinois Water Science Center
Stream 7.6 mi261 mg/L12000
Hickory Creek
illinois epa (State)
River/Stream 8.4 mi409 mg/L252000–2002
Des Plaines River
illinois epa (State)
River/Stream 8.5 mi179 mg/L12000
DES PLAINES RIVER AB BRANDON RD DM AT JOLIET, IL
USGS Illinois Water Science Center
Stream 8.5 mi216 mg/L42015

Water hardness in towns near Manhattan

TownDistanceMedianClass
New Lenox6 mi 237 mg/LVery hard
Frankfort8 mi 236 mg/LVery hard
Mokena9 mi 236 mg/LVery hard
Joliet11 mi 248 mg/LVery hard
Lockport12 mi 250 mg/LVery hard
Crest Hill13 mi 255 mg/LVery hard
Homer Glen13 mi 252 mg/LVery hard
Richton Park13 mi 282 mg/LVery hard
Matteson14 mi 239 mg/LVery hard
Tinley Park14 mi 206 mg/LVery hard

Will County

Manhattan is in Will County, where the median is 280 mg/L (very hard) across 38 sites.

See all of Will County →

Illinois

The statewide median is 293 mg/L (very hard) from 1,100 sites.

Illinois hardness map →

Manhattan, IL water: common questions

Do I need a water softener in Manhattan?

Very likely. Water measured around Manhattan is 13.9 gpg (237 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 24,000 grains.Size it for your household →

Who supplies Manhattan's drinking water?

The main public water system serving Manhattan in EPA records is Manhattan. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Manhattan?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next