Water hardness in Selma, AL

Water in Selma is soft, with a median of 33 mg/L (1.9 grains per gallon) across 8 monitoring sites within 10 miles.

27% softer than the Alabama median (45 mg/L) 54th hardest of 69 Alabama towns Population 16,666
33mg/L
1.9 grains per gallon
Soft

Selma tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 33 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.9 gpg (1.8 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites8
Lab samples90
Sample years2000–2026
Middle 50% of sites9–81 mg/L
Groundwater (wells, springs)58 mg/L · 2 sites
Surface water (rivers, lakes)33 mg/L · 6 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Selma

Prefilled with Selma's measured local hardness of 33 mg/L (1.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Selma tap water

Selma Water Works & Sewer Board is the main public water system for Selma. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Oct 2024 – Apr 2025. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Selma

Water systemPFAS detectedHighest PFOA / PFOSTested
North Dallas Water Authority
serves 10,000 people or fewer
None detected — Apr 2025 – Oct 2025
South Dallas Water Authority
serves 10,000 people or fewer
None detected — Mar 2023 – Dec 2023
Dallas County Water & Sewer Authority
serves 10,000 people or fewer
None detected — Jan 2024 – Aug 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Selma

City of Selma, the WW and SB of the reported 8,951 service lines (the pipes connecting homes to the water main) in its inventory. 930 are lead and 302 are galvanized lines that must be replaced, and 7,268 are still of unknown material.

930lead (10%)
302galvanized requiring replacement
7,268unknown material (81%)
451not lead (5%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Selma, the WW and SB of the whether your address is on its list.

Other water systems serving parts of Selma

Water systemService linesTotal
North Dallas County Water Authority0 lead · 1 galvanized · 3,203 unknown3,721
South Dallas Water Authority0 lead · 0 galvanized · 17 unknown2,207
Dallas County Water & Sewer Authority0 lead · 0 galvanized · 88 unknown1,758

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Selma drinking water violations

EPA records show no health-based violations for Selma Water Works & Sewer Board since 2016. It also had 8 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Selma

Water systemHealth-based violationsMonitoring/reporting
North Dallas Water AuthorityNone37
South Dallas Water AuthorityNone2
Dallas County Water & Sewer AuthorityNone32

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Selma

SiteTypeDistanceMedianSamplesYears
Well J 24 Selma PWS 1988-89 Dallas Cnty Al
USGS Alabama Water Science Center
Well 2 mi110 mg/L12013
CHLD-2
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 3.3 mi15 mg/L62002–2020
OKGD-3
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 6.9 mi7 mg/L42019
DANW-6
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 7 mi84 mg/L162000–2015
CAHD-1A
ALABAMA DEPT. OF ENVIRONMENTAL MANAGEMENT - WATER QUALITY DATA
River/Stream 7.4 mi80 mg/L232015–2026
NAWQA FLH-22-1
USGS Alabama Water Science Center
Well 8.2 mi5 mg/L12019

Water hardness in towns near Selma

TownDistanceMedianClass
Prattville34 mi 33 mg/LSoft
Millbrook39 mi 33 mg/LSoft
Montgomery45 mi 33 mg/LSoft
Calera52 mi 160 mg/LHard
Pike Road54 mi 45 mg/LSoft
Alabaster56 mi 155 mg/LHard
Helena61 mi 119 mg/LModerately hard
Tuscaloosa63 mi 43 mg/LSoft
Pelham65 mi 116 mg/LModerately hard
Chelsea66 mi 103 mg/LModerately hard

Dallas County

Selma is in Dallas County, where the median is 61 mg/L (moderately hard) across 29 sites.

See all of Dallas County →

Alabama

The statewide median is 45 mg/L (soft) from 2,227 sites.

Alabama hardness map →

Selma, AL water: common questions

Do I need a water softener in Selma?

Probably not. Water measured around Selma is 1.9 gpg (33 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Selma's drinking water?

The main public water system serving Selma in EPA records is Selma Water Works & Sewer Board. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Selma?

It depends on what you want to remove. In Selma, the system reports 930 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next