Water hardness in Gillette, WY

Water in Gillette is very hard, with a median of 532 mg/L (31.1 grains per gallon) across 8 monitoring sites within 10 miles.

177% harder than the Wyoming median (192 mg/L) 2nd hardest of 11 Wyoming towns Population 33,496
532mg/L
31.1 grains per gallon
Very hard

Gillette tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 532 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 31.1 gpg (29.8 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites8
Lab samples16
Sample years2015–2016
Middle 50% of sites174–591 mg/L
Groundwater (wells, springs)532 mg/L · 8 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Gillette

Prefilled with Gillette's measured local hardness of 532 mg/L (31.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Gillette tap water

City of Gillette is the main public water system for Gillette. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Nov 2024 – May 2025. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Gillette

City of Gillette reported 9,887 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 4,714 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
4,714unknown material (48%)
5,173not lead (52%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Gillette drinking water violations

EPA records show no health-based violations for City of Gillette since 2016. It also had 2 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Gillette

SiteTypeDistanceMedianSamplesYears
50-072-32dabc01
USGS Wyoming Water Science Center
Well 1.8 mi624 mg/L22016
49-072-09bcb01
USGS Wyoming Water Science Center
Well 2.6 mi41 mg/L22015
50-071-19dcac01
USGS Wyoming Water Science Center
Well 3.4 mi218 mg/L22016
50-071-20ccb01
USGS Wyoming Water Science Center
Well 3.8 mi1200 mg/L22016
50-073-28ddd01
USGS Wyoming Water Science Center
Well 6.6 mi580 mg/L22015
49-072-35cda01
USGS Wyoming Water Science Center
Well 6.7 mi543 mg/L22016

Water hardness in towns near Gillette

TownDistanceMedianClass
Sheridan81 mi 451 mg/LVery hard
Casper107 mi 166 mg/LHard
Riverton168 mi 560 mg/LVery hard
Cody177 mi 239 mg/LVery hard
Laramie205 mi 212 mg/LVery hard
Cheyenne220 mi 126 mg/LHard
Rock Springs264 mi 227 mg/LVery hard
Jackson269 mi 151 mg/LHard
Green River277 mi 348 mg/LVery hard
Evanston347 mi 220 mg/LVery hard

Campbell County

Gillette is in Campbell County, where the median is 510 mg/L (very hard) across 47 sites.

See all of Campbell County →

Wyoming

The statewide median is 192 mg/L (very hard) from 810 sites.

Wyoming hardness map →

Gillette, WY water: common questions

Do I need a water softener in Gillette?

Very likely. Water measured around Gillette is 31.1 gpg (532 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 54,000 grains.Size it for your household →

Who supplies Gillette's drinking water?

The main public water system serving Gillette in EPA records is City of Gillette. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Gillette?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next