Water hardness in Seabrook, TX

Water in Seabrook is very hard, with a median of 532 mg/L (31.1 grains per gallon) across 16 monitoring sites within 10 miles.

174% harder than the Texas median (194 mg/L) 6th hardest of 251 Texas towns Population 13,662
532mg/L
31.1 grains per gallon
Very hard

Seabrook tap water at a glance

  • HardnessVery hard (532 mg/L, 31.1 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • PFAS5 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 532 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 31.1 gpg (29.8 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites16
Lab samples149
Sample years2000–2005
Middle 50% of sites285–930 mg/L
Surface water (rivers, lakes)532 mg/L · 16 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Seabrook

Prefilled with Seabrook's measured local hardness of 532 mg/L (31.1 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Seabrook tap water

City of Seabrook is the main public water system for Seabrook. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 6 samples taken Mar 2023 – Dec 2023. 5 PFAS were detected. Every result with a federal limit was at or below it.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
8.8 ppt 2 of 6 samples —
PFPeA
perfluoropentanoic acid
7.9 ppt 2 of 6 samples —
PFHxA
perfluorohexanoic acid
7 ppt 2 of 6 samples —
PFBS
perfluorobutane sulfonic acid
4.2 ppt 2 of 6 samples —
PFHxS
perfluorohexane sulfonic acid
3.7 ppt 2 of 6 samples 10 ppt*

Other water systems serving parts of Seabrook

Water systemPFAS detectedHighest PFOA / PFOSTested
Clear Lake City Water Authority
serves over 10,000 people
PFBA, PFHxA, PFPeA +5 more 4 / 6.7 ppt Apr 2023 – Mar 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Seabrook

City of Seabrook reported 4,112 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 38 are galvanized lines that must be replaced.

0lead (0%)
38galvanized requiring replacement
0unknown material (0%)
4,074not lead (99%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Seabrook whether your address is on its list.

Other water systems serving parts of Seabrook

Water systemService linesTotal
Clear Lake City Water Authority0 lead · 1 galvanized · 59 unknown17,797

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Seabrook drinking water violations

EPA records show no health-based violations for City of Seabrook since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Seabrook

Water systemHealth-based violationsMonitoring/reporting
Clear Lake City Water AuthorityNone2

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Seabrook

SiteTypeDistanceMedianSamplesYears
JARBO BAYOU AT FM2094
Texas Commission on Environmental Quality
River/Stream 4.3 mi700 mg/L32002–2003
JARBO BAYOU AT LAWRENCE ROAD
Texas Commission on Environmental Quality
River/Stream 5 mi1300 mg/L52002–2003
CLEAR CREEK TDL AT THE CONFLUENCE WITH CLEAR LAKE
Texas Commission on Environmental Quality
River/Stream 6.3 mi924 mg/L42002–2003
CLEAR CK TDL AT ROBINSONS BAYOU
Texas Commission on Environmental Quality
River/Stream 6.8 mi860 mg/L42002–2003
ROBINSONS BAYOU AT FM270
Texas Commission on Environmental Quality
River/Stream 7.3 mi266 mg/L52002–2003
ROBINSONS BAYOU AT WEBSTER
Texas Commission on Environmental Quality
River/Stream 7.5 mi291 mg/L62002–2003

Water hardness in towns near Seabrook

TownDistanceMedianClass
La Porte6 mi 750 mg/LVery hard
Webster9 mi 216 mg/LVery hard
Deer Park10 mi 334 mg/LVery hard
League City10 mi 206 mg/LVery hard
Pasadena10 mi 222 mg/LVery hard
Dickinson11 mi 234 mg/LVery hard
Baytown12 mi 620 mg/LVery hard
Texas City13 mi 300 mg/LVery hard
Friendswood14 mi 189 mg/LVery hard
South Houston15 mi 164 mg/LHard

Chambers County

Seabrook is in Chambers County, where the median is 281 mg/L (very hard) across 5 sites.

See all of Chambers County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Seabrook, TX water: common questions

Do I need a water softener in Seabrook?

Very likely. Water measured around Seabrook is 31.1 gpg (532 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 54,000 grains.Size it for your household →

Who supplies Seabrook's drinking water?

The main public water system serving Seabrook in EPA records is City of Seabrook. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Seabrook?

It depends on what you want to remove. In Seabrook, EPA testing found PFBA, PFPeA and PFHxA and 2 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next