Water hardness in Sachse, TX

Water in Sachse is moderately hard, with a median of 117 mg/L (6.8 grains per gallon) across 17 monitoring sites within 10 miles.

40% softer than the Texas median (194 mg/L) 204th hardest of 251 Texas towns Population 32,294
117mg/L
6.8 grains per gallon
Moderately hard

Sachse tap water at a glance

  • HardnessModerately hard (117 mg/L, 6.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS4 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo lead service lines reported.Details →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 117 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 6.8 gpg (6.6 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites17
Lab samples1,203
Sample years2000–2023
Middle 50% of sites110–126 mg/L
Surface water (rivers, lakes)117 mg/L · 17 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Sachse

Prefilled with Sachse's measured local hardness of 117 mg/L (6.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Sachse tap water

City of Sachse is the main public water system for Sachse. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Jun 2024 – Jul 2025. 4 PFAS were detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
10 ppt 2 of 4 samples —
PFPeA
perfluoropentanoic acid
5.6 ppt 3 of 4 samples —
PFHxA
perfluorohexanoic acid
5.6 ppt 3 of 4 samples —
PFBS
perfluorobutane sulfonic acid
4.1 ppt 3 of 4 samples —

Other water systems serving parts of Sachse

Water systemPFAS detectedHighest PFOA / PFOSTested
City of Plano
serves over 10,000 people
PFBA, PFHxA, PFPeA +1 more — Feb 2025 – Nov 2025
City of Wylie
serves over 10,000 people
PFPeA, PFBA, PFHxA +1 more — Apr 2023 – Feb 2024
East Fork Sud
serves over 10,000 people
PFBA, PFPeA, PFHxA +1 more — Nov 2024 – Aug 2025
City of Murphy
serves over 10,000 people
PFBA, PFPeA, PFHxA +1 more — Aug 2024 – May 2025
City of Garland
serves over 10,000 people
PFBA, PFPeA, PFHxA +1 more — Jan 2024 – Dec 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Sachse

City of Sachse reported 9,636 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
9,636not lead (100%)

Other water systems serving parts of Sachse

Water systemService linesTotal
City of Plano0 lead · 1 galvanized · 0 unknown83,917
City of Wylie0 lead · 14 galvanized · 0 unknown13,186
East Fork Sud0 lead · 0 galvanized · 0 unknown6,018
City of Murphy0 lead · 0 galvanized · 0 unknown6,470
City of Garland0 lead · 0 galvanized · 34,006 unknown73,835

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Sachse drinking water violations

EPA records show no health-based violations for City of Sachse since 2016.

Other water systems serving parts of Sachse

Water systemHealth-based violationsMonitoring/reporting
City of PlanoNone0
City of WylieNone0
East Fork SudNone1
City of MurphyNone2
City of GarlandNone3

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Sachse

SiteTypeDistanceMedianSamplesYears
ROWLETT CREEK AT SH 78
Texas Commission on Environmental Quality
River/Stream 2.1 mi212 mg/L242000–2003
MUDDY CREEK AT LIBERTY GROVE R
Texas Commission on Environmental Quality
River/Stream 3.4 mi168 mg/L302000–2003
Lk Ray Hubbard nr Cottonwood Ck nr Rockwall, TX
USGS Texas Water Science Center
Lake, Reservoir, Impoundment 4.7 mi124 mg/L1402016–2023
Lk Ray Hubbard nr Muddy Ck nr Rowlett, TX
USGS Texas Water Science Center
Lake, Reservoir, Impoundment 5.8 mi110 mg/L1402016–2023
LAKE RAY HUBBARD AT US 66
Texas Commission on Environmental Quality
Reservoir 6 mi126 mg/L362000–2003
Lavon Lk at Raw Water Intake #2
USGS Texas Water Science Center
Lake, Reservoir, Impoundment 6.5 mi114 mg/L602011–2023

Water hardness in towns near Sachse

TownDistanceMedianClass
Murphy4 mi 124 mg/LHard
Rowlett4 mi 118 mg/LModerately hard
Garland5 mi 118 mg/LModerately hard
Wylie6 mi 111 mg/LModerately hard
Richardson7 mi 212 mg/LVery hard
Rockwall9 mi 118 mg/LModerately hard
Heath10 mi 118 mg/LModerately hard
Allen11 mi 111 mg/LModerately hard
Plano11 mi 212 mg/LVery hard
Fate11 mi 117 mg/LModerately hard

Collin County

Sachse is in Collin County, where the median is 111 mg/L (moderately hard) across 7 sites.

See all of Collin County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Sachse, TX water: common questions

Do I need a water softener in Sachse?

Probably not. Water measured around Sachse is 6.8 gpg (117 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 12,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Sachse's drinking water?

The main public water system serving Sachse in EPA records is City of Sachse. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Sachse?

It depends on what you want to remove. In Sachse, EPA testing found PFBA, PFPeA and PFHxA and 1 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next