Water hardness in Red Oak, TX
Water in Red Oak is hard, with a median of 125 mg/L (7.3 grains per gallon) across Ellis County.
There are not enough monitoring sites within 10 miles of Red Oak, so this page uses the Ellis County median.
Red Oak tap water at a glance
- HardnessHard (125 mg/L, 7.3 gpg, local measurements). Scale on fixtures, kettles and water heaters is likely.Size a water softener →
- PFAS4 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 125 mg/L means at home
- Water softener: Many households here choose a softener to protect water heaters and appliances from scale.
- Dishwasher: set the water hardness to about 7.3 gpg (7 °dH), which is a medium-to-high hardness setting, with rinse aid.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Red Oak
Prefilled with Red Oak's measured local hardness of 125 mg/L (7.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Red Oak tap water
City of Red Oak is the main public water system for Red Oak. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken May 2023 – Apr 2024. 4 PFAS were detected.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBA perfluorobutanoic acid | 10.2 ppt | 4 of 4 samples | — |
| PFPeA perfluoropentanoic acid | 6.1 ppt | 3 of 4 samples | — |
| PFHxA perfluorohexanoic acid | 5.8 ppt | 3 of 4 samples | — |
| PFBS perfluorobutane sulfonic acid | 4.9 ppt | 3 of 4 samples | — |
Other water systems serving parts of Red Oak
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Rockett Sud serves over 10,000 people | PFBA, PFPeA, PFHxA +1 more | — | May 2024 – Feb 2025 |
| Sardis Lone ELM WSC serves over 10,000 people | PFBA, PFPeA, PFHxA +1 more | — | Jul 2024 – Jun 2025 |
| City of Glenn Heights serves over 10,000 people | PFBA, PFPeA, PFHxA +1 more | — | May 2023 – Feb 2024 |
| City of Waxahachie serves over 10,000 people | PFPeA, PFBA, PFHxA +1 more | — | Nov 2023 – Aug 2024 |
| Mountain Peak Sud serves over 10,000 people | PFBA, PFPeA, PFOS +2 more | ND / 6.2 ppt | Sep 2023 – Dec 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Red Oak
City of Red Oak reported 4,127 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 31 are galvanized lines that must be replaced.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Red Oak whether your address is on its list.
Other water systems serving parts of Red Oak
| Water system | Service lines | Total |
|---|---|---|
| Rockett Sud | 0 lead · 0 galvanized · 4,078 unknown | 15,340 |
| Sardis Lone ELM WSC | 0 lead · 0 galvanized · 1 unknown | 7,170 |
| City of Glenn Heights | 0 lead · 0 galvanized · 0 unknown | 7,087 |
| City of Waxahachie | 2 lead · 19 galvanized · 0 unknown | 16,591 |
| Mountain Peak Sud | 0 lead · 0 galvanized · 2,666 unknown | 7,687 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Red Oak drinking water violations
EPA records show no health-based violations for City of Red Oak since 2016.
Other water systems serving parts of Red Oak
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Rockett Sud | None | 7 |
| Sardis Lone ELM WSC | None | 0 |
| City of Glenn Heights | None | 16 |
| City of Waxahachie | None | 8 |
| Mountain Peak Sud | 1 | 8 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Red Oak
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| JK-33-25-902 USGS Texas Water Science Center | Well | 7.3 mi | 10 mg/L | 1 | 2016 |
Water hardness in towns near Red Oak
| Town | Distance | Median | Class |
|---|---|---|---|
| Glenn Heights | 5 mi | 163 mg/L | Hard |
| Lancaster | 6 mi | 171 mg/L | Hard |
| DeSoto | 8 mi | 160 mg/L | Hard |
| Waxahachie | 8 mi | 216 mg/L | Very hard |
| Cedar Hill | 11 mi | 161 mg/L | Hard |
| Duncanville | 12 mi | 160 mg/L | Hard |
| Midlothian | 12 mi | 166 mg/L | Hard |
| Ennis | 15 mi | 120 mg/L | Moderately hard |
| Seagoville | 17 mi | 167 mg/L | Hard |
| Balch Springs | 17 mi | 164 mg/L | Hard |
Ellis County
Red Oak is in Ellis County, where the median is 125 mg/L (hard) across 13 sites.
See all of Ellis County →Red Oak, TX water: common questions
Do I need a water softener in Red Oak?
Many homes here use one. Water measured around Red Oak is 7.3 gpg (125 mg/L, measured locally), above the 7 gpg (120 mg/L) level where scale on fixtures, appliances and water heaters becomes noticeable. For a 3-person home that regenerates weekly, that means a softener of about 13,000 grains.Size it for your household →
Who supplies Red Oak's drinking water?
The main public water system serving Red Oak in EPA records is City of Red Oak. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Red Oak?
It depends on what you want to remove. In Red Oak, EPA testing found PFBA, PFPeA and PFHxA and 1 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Do you need a water softener?Water here is hard; size a softener with our calculator.
- Which water filters remove PFAS?EPA tests found 4 PFAS in Red Oak's main water system.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.