Water hardness in Lumberton, TX

Water in Lumberton is soft, with a median of 29 mg/L (1.7 grains per gallon) across 11 monitoring sites within 10 miles.

85% softer than the Texas median (194 mg/L) 248th hardest of 251 Texas towns Population 14,129
29mg/L
1.7 grains per gallon
Soft

Lumberton tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 29 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 1.7 gpg (1.6 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites11
Lab samples237
Sample years2000–2015
Middle 50% of sites20–33 mg/L
Groundwater (wells, springs)38 mg/L · 2 sites
Surface water (rivers, lakes)29 mg/L · 9 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Lumberton

Prefilled with Lumberton's measured local hardness of 29 mg/L (1.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Lumberton tap water

Lumberton MUD is the main public water system for Lumberton. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Feb 2025 – Aug 2025. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Lumberton

Water systemPFAS detectedHighest PFOA / PFOSTested
West Hardin WSC
serves 10,000 people or fewer
None detected — Jan 2025 – Aug 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Lumberton

Lumberton MUD reported 10,076 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
10,076not lead (100%)

Other water systems serving parts of Lumberton

Water systemService linesTotal
West Hardin WSC39 lead · 0 galvanized · 1,079 unknown1,817

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Lumberton drinking water violations

EPA records show no health-based violations for Lumberton MUD since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Lumberton

Water systemHealth-based violationsMonitoring/reporting
West Hardin WSC112

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Lumberton

SiteTypeDistanceMedianSamplesYears
Village Creek at State Park
National Park Service Water Resources Division
River/Stream 2.1 mi20 mg/L132014–2015
VILLAGE CREEK AT US 96
Texas Commission on Environmental Quality
River/Stream 2.3 mi18 mg/L242002–2005
Village Creek at Neches River Confluence
National Park Service Water Resources Division
River/Stream 5.3 mi21 mg/L342007–2014
PINE ISLAND BAYOU AT US 69
Texas Commission on Environmental Quality
River/Stream 5.4 mi34 mg/L302000–2005
LH-61-54-303
USGS Texas Water Science Center
Well 5.5 mi68 mg/L12005
NECHES RIVER NEAR LAKEVIEW
Texas Commission on Environmental Quality
River/Stream 6.1 mi31 mg/L302000–2006

Water hardness in towns near Lumberton

TownDistanceMedianClass
Beaumont12 mi 49 mg/LSoft
Nederland23 mi 182 mg/LVery hard
Port Neches25 mi 260 mg/LVery hard
Groves28 mi 260 mg/LVery hard
Orange29 mi 60 mg/LSoft
Port Arthur31 mi 260 mg/LVery hard
Baytown57 mi 620 mg/LVery hard
Atascocita62 mi 98 mg/LModerately hard
Channelview63 mi 272 mg/LVery hard
La Porte65 mi 750 mg/LVery hard

Hardin County

Lumberton is in Hardin County, where the median is 32 mg/L (soft) across 17 sites.

See all of Hardin County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Lumberton, TX water: common questions

Do I need a water softener in Lumberton?

Probably not. Water measured around Lumberton is 1.7 gpg (29 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →

Who supplies Lumberton's drinking water?

The main public water system serving Lumberton in EPA records is Lumberton MUD. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Lumberton?

Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next