Water hardness in Ingleside, TX
Water in Ingleside is soft, with a median of 48 mg/L (2.8 grains per gallon) across Nueces County.
There are not enough monitoring sites within 10 miles of Ingleside, so this page uses the Nueces County median.
Ingleside tap water at a glance
- HardnessSoft (48 mg/L, 2.8 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFAS3 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesThe water system reported 3 lead service lines.Check your own pipe →
- Violations1 health-based violation since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 48 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.8 gpg (2.7 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Ingleside
Prefilled with Ingleside's measured local hardness of 48 mg/L (2.8 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Ingleside tap water
City of Ingleside is the main public water system for Ingleside. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Mar 2024 – Feb 2025. 3 PFAS were detected.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBA perfluorobutanoic acid | 8.2 ppt | 7 of 8 samples | — |
| PFPeA perfluoropentanoic acid | 3.7 ppt | 2 of 8 samples | — |
| PFBS perfluorobutane sulfonic acid | 3 ppt | 1 of 8 samples | — |
Other water systems serving parts of Ingleside
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Nueces County Wcid 4 serves over 10,000 people | PFBA | — | Jun 2023 – Mar 2024 |
| City of Portland serves over 10,000 people | PFBA, PFPeA, PFHxA | — | Apr 2023 – Jan 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Ingleside
City of Ingleside reported 3,549 service lines (the pipes connecting homes to the water main) in its inventory. 3 are lead and 4 are galvanized lines that must be replaced.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Ingleside whether your address is on its list.
Other water systems serving parts of Ingleside
| Water system | Service lines | Total |
|---|---|---|
| Nueces County Wcid 4 | 0 lead · 0 galvanized · 0 unknown | 5,333 |
| City of Portland | 0 lead · 0 galvanized · 0 unknown | 6,450 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Ingleside drinking water violations
EPA records show 1 health-based violation for City of Ingleside since 2016, all since resolved or closed. The most recent began in Oct 2024. It also had 25 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Lead and Copper Rule Revisions lead service line inventory and lead rule requirements | Treatment requirement not met | 1 | Oct 2024 | Resolved/closed |
Other water systems serving parts of Ingleside
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Nueces County Wcid 4 | 4 | 1 |
| City of Portland | 2 | 2 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Water hardness in towns near Ingleside
| Town | Distance | Median | Class |
|---|---|---|---|
| Corpus Christi | 8 mi | 48 mg/L | Soft |
| Rockport | 16 mi | 218 mg/L | Very hard |
| Robstown | 29 mi | 48 mg/L | Soft |
| Beeville | 50 mi | 476 mg/L | Very hard |
| Alice | 53 mi | 180 mg/L | Hard |
| Victoria | 68 mi | 301 mg/L | Very hard |
| Bay City | 108 mi | 154 mg/L | Hard |
| Pleasanton | 109 mi | 183 mg/L | Very hard |
| Harlingen | 120 mi | 346 mg/L | Very hard |
| Edinburg | 122 mi | 232 mg/L | Very hard |
Nueces County
Ingleside is in Nueces County, where the median is 48 mg/L (soft) across 2 sites.
See all of Nueces County →Ingleside, TX water: common questions
Do I need a water softener in Ingleside?
Probably not. Water measured around Ingleside is 2.8 gpg (48 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Ingleside's drinking water?
The main public water system serving Ingleside in EPA records is City of Ingleside. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Ingleside?
It depends on what you want to remove. In Ingleside, EPA testing found PFBA, PFPeA and PFBS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system reports 3 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced; the system had 1 health-based violation since 2016, for the Lead and Copper Rule Revisions; the utility's annual report says what was done about it. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 3 PFAS in Ingleside's main water system.
- How to tell if your home has a lead pipe3 lead service lines are reported here.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.