Water hardness in Beeville, TX

Water in Beeville is very hard, with a median of 476 mg/L (27.8 grains per gallon) across Bee County.

145% harder than the Texas median (194 mg/L) 9th hardest of 251 Texas towns Population 13,211
476mg/L
27.8 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of Beeville, so this page uses the Bee County median.

Beeville tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 476 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 27.8 gpg (26.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites1
Lab samples9
Sample years2000–2002
Middle 50% of sites476–476 mg/L
Surface water (rivers, lakes)476 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Beeville

Prefilled with Beeville's measured local hardness of 476 mg/L (27.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Beeville tap water

City of Beeville is the main public water system for Beeville. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 6 samples taken Oct 2024 – Sep 2025. 4 PFAS were detected. Every result with a federal limit was at or below it.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
15.2 ppt 2 of 5 samples —
PFHxS
perfluorohexane sulfonic acid
4.7 ppt 3 of 5 samples 10 ppt*
PFHxA
perfluorohexanoic acid
3.4 ppt 1 of 5 samples —
PFPeA
perfluoropentanoic acid
3.1 ppt 1 of 5 samples —

Other water systems serving parts of Beeville

Water systemPFAS detectedHighest PFOA / PFOSTested
TDCJ Chase Field
serves 10,000 people or fewer
None detected — Jun 2023 – Mar 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Beeville

City of Beeville reported 5,510 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 19 are galvanized lines that must be replaced.

0lead (0%)
19galvanized requiring replacement
0unknown material (0%)
5,491not lead (100%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Beeville whether your address is on its list.

Other water systems serving parts of Beeville

Water systemService linesTotal
TDCJ Chase Field0 lead · 0 galvanized · 0 unknown141

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Beeville drinking water violations

EPA records show 19 health-based violations for City of Beeville since 2016, all since resolved or closed. The most recent began in Oct 2024. It also had 35 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Contaminant or ruleTypeViolationsMost recentStatus
Total trihalomethanes (TTHM)
byproducts formed when chlorine reacts with natural matter in water · what it means
highest measured 0.114 MG/L; limit 0.080 mg/L
Contaminant above legal limit 14 Oct 2024 Resolved/closed
Coliform bacteria / E. coli (Revised Total Coliform Rule)
bacteria that signal possible contamination of the system · what it means
Contaminant above legal limit 1 Jul 2019 Resolved/closed
Haloacetic acids (HAA5)
byproducts of chlorine disinfection · what it means
highest measured 0.11 MG/L; limit 0.060 mg/L
Contaminant above legal limit 4 Jul 2018 Resolved/closed

Other water systems serving parts of Beeville

Water systemHealth-based violationsMonitoring/reporting
TDCJ Chase Field116

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Beeville

SiteTypeDistanceMedianSamplesYears
ARANSAS CREEK AT US 181
Texas Commission on Environmental Quality
River/Stream 9.5 mi476 mg/L92000–2002

Water hardness in towns near Beeville

TownDistanceMedianClass
Robstown43 mi 48 mg/LSoft
Alice49 mi 180 mg/LHard
Rockport49 mi 218 mg/LVery hard
Ingleside50 mi 48 mg/LSoft
Victoria55 mi 301 mg/LVery hard
Corpus Christi57 mi 48 mg/LSoft
Pleasanton60 mi 183 mg/LVery hard
Seguin83 mi 236 mg/LVery hard
Converse84 mi 264 mg/LVery hard
Cibolo85 mi 264 mg/LVery hard

Bee County

Beeville is in Bee County, where the median is 476 mg/L (very hard) across 1 sites.

See all of Bee County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Beeville, TX water: common questions

Do I need a water softener in Beeville?

Very likely. Water measured around Beeville is 27.8 gpg (476 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 48,000 grains.Size it for your household →

Who supplies Beeville's drinking water?

The main public water system serving Beeville in EPA records is City of Beeville. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Beeville?

It depends on what you want to remove. In Beeville, EPA testing found PFBA, PFHxS and PFHxA and 1 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system had 19 health-based violations since 2016, for TTHM and the Revised Total Coliform Rule and more; the utility's annual report says what was done about them. On the other hand, no lead service lines reported. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next