Water hardness in Willoughby, OH

Water in Willoughby is very hard, with a median of 200 mg/L (11.7 grains per gallon) across 44 monitoring sites within 10 miles.

28% softer than the Ohio median (276 mg/L) 160th hardest of 183 Ohio towns Population 24,163
200mg/L
11.7 grains per gallon
Very hard

Willoughby tap water at a glance

  • HardnessVery hard (200 mg/L, 11.7 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 200 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 11.7 gpg (11.2 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites44
Lab samples458
Sample years2000–2024
Middle 50% of sites179–240 mg/L
Groundwater (wells, springs)169 mg/L · 3 sites
Surface water (rivers, lakes)203 mg/L · 41 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Willoughby

Prefilled with Willoughby's measured local hardness of 200 mg/L (11.7 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Willoughby tap water

Willoughby is served by more than one water system. These systems supply ZIP codes in Willoughby and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Willoughby

Water systemPFAS detectedHighest PFOA / PFOSTested
Cleveland Public Water System
serves over 10,000 people
None detected — Sep 2024 – Jun 2025
Lake County West Water Subdistrict
serves over 10,000 people
None detected — Feb 2025 – Nov 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Willoughby

Willoughby is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Willoughby

Water systemService linesTotal
Cleveland Public Water System144,193 lead · 528 galvanized · 56,954 unknown434,395
Lake County West Water Subdistrict1 lead · 0 galvanized · 22,556 unknown27,914

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Willoughby drinking water violations

Willoughby is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Willoughby

Water systemHealth-based violationsMonitoring/reporting
Cleveland Public Water SystemNone9
Lake County West Water SubdistrictNone2

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Willoughby

SiteTypeDistanceMedianSamplesYears
CHAGRIN R. @ PARK OFF REEVES RD.
Division of Surface water (Ohio) (State)
River/Stream 0.9 mi206 mg/L32003
CHAGRIN R. AT WILLOUGHBY @ RIDGE RD. (ST. RT. 84)
Division of Surface water (Ohio) (State)
River/Stream 1.3 mi186 mg/L1412000–2024
GULLY BROOK (CHAGRIN R. 5.54) @ RIVER RD. (ST. RT. 174)
Division of Surface water (Ohio) (State)
River/Stream 1.7 mi298 mg/L62004
WARD CREEK @ PUMP STATION AT CULDESAC OFF REEVES RD.
Division of Surface water (Ohio) (State)
River/Stream 1.7 mi218 mg/L62004
E. BR. CHAGRIN R. AT KIRTLAND @ MARKELL RD.
Division of Surface water (Ohio) (State)
River/Stream 2.5 mi239 mg/L202003–2004
STONY BROOK (E BR CHAGRIN 3.57) @ KIRTLAND-CHARDON RD.
Division of Surface water (Ohio) (State)
River/Stream 3 mi290 mg/L62004

Water hardness in towns near Willoughby

TownDistanceMedianClass
Eastlake1 mi 197 mg/LVery hard
Willowick3 mi 200 mg/LVery hard
Wickliffe4 mi 203 mg/LVery hard
Mentor5 mi 203 mg/LVery hard
Euclid7 mi 185 mg/LVery hard
Richmond Heights8 mi 186 mg/LVery hard
Mayfield Heights9 mi 186 mg/LVery hard
Painesville10 mi 190 mg/LVery hard
Lyndhurst10 mi 188 mg/LVery hard
South Euclid10 mi 191 mg/LVery hard

Lake County

Willoughby is in Lake County, where the median is 194 mg/L (very hard) across 61 sites.

See all of Lake County →

Ohio

The statewide median is 276 mg/L (very hard) from 6,849 sites.

Ohio hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next