Water hardness in Richmond Heights, OH

Water in Richmond Heights is very hard, with a median of 186 mg/L (10.8 grains per gallon) across 40 monitoring sites within 10 miles.

33% softer than the Ohio median (276 mg/L) 172nd hardest of 183 Ohio towns Population 10,509
186mg/L
10.8 grains per gallon
Very hard

Richmond Heights tap water at a glance

  • HardnessVery hard (186 mg/L, 10.8 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 186 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 10.8 gpg (10.4 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites40
Lab samples466
Sample years2000–2024
Middle 50% of sites168–234 mg/L
Groundwater (wells, springs)234 mg/L · 2 sites
Surface water (rivers, lakes)186 mg/L · 38 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Richmond Heights

Prefilled with Richmond Heights's measured local hardness of 186 mg/L (10.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Richmond Heights tap water

Richmond Heights is served by more than one water system. These systems supply ZIP codes in Richmond Heights and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Richmond Heights

Water systemPFAS detectedHighest PFOA / PFOSTested
Cleveland Public Water System
serves over 10,000 people
None detected — Sep 2024 – Jun 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Richmond Heights

Richmond Heights is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Richmond Heights

Water systemService linesTotal
Cleveland Public Water System144,193 lead · 528 galvanized · 56,954 unknown434,395

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Richmond Heights drinking water violations

Richmond Heights is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Richmond Heights

Water systemHealth-based violationsMonitoring/reporting
Cleveland Public Water SystemNone9

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Richmond Heights

SiteTypeDistanceMedianSamplesYears
E. BR. EUCLID CREEK NEAR MOUTH, UPST. OLD DAM (FREE-FLOWING)
Division of Surface water (Ohio) (State)
River/Stream 1.1 mi181 mg/L72015–2016
E. BR. EUCLID CREEK AT RICHMOND HEIGHTS @ RICHMOND RD.
Division of Surface water (Ohio) (State)
River/Stream 1.2 mi185 mg/L62015–2016
EUCLID CREEK NEAR EUCLID @ HIGHLAND RD. (UPPER CROSSING)
Division of Surface water (Ohio) (State)
River/Stream 1.2 mi182 mg/L12016
E. BR. EUCLID CREEK @ MOUTH, DST. DAM
Division of Surface water (Ohio) (State)
River/Stream 1.2 mi164 mg/L62000
EUCLID CREEK @ EUCLID PARK BLVD.
Division of Surface water (Ohio) (State)
River/Stream 1.2 mi195 mg/L142000–2016
Tributary to Euclid Creek (5.49) NEAR EUCLID @ ANDERSON RD.
Division of Surface water (Ohio) (State)
River/Stream 1.9 mi203 mg/L52015–2016

Water hardness in towns near Richmond Heights

TownDistanceMedianClass
Euclid2 mi 185 mg/LVery hard
South Euclid3 mi 191 mg/LVery hard
Lyndhurst3 mi 188 mg/LVery hard
Wickliffe4 mi 203 mg/LVery hard
Mayfield Heights4 mi 186 mg/LVery hard
East Cleveland4 mi 189 mg/LVery hard
Cleveland Heights4 mi 196 mg/LVery hard
University Heights5 mi 200 mg/LVery hard
Willowick5 mi 200 mg/LVery hard
Beachwood6 mi 200 mg/LVery hard

Cuyahoga County

Richmond Heights is in Cuyahoga County, where the median is 201 mg/L (very hard) across 148 sites.

See all of Cuyahoga County →

Ohio

The statewide median is 276 mg/L (very hard) from 6,849 sites.

Ohio hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next