Water hardness in Murraysville, NC

Water in Murraysville is very hard, with a median of 248 mg/L (14.5 grains per gallon) across 97 monitoring sites within 10 miles.

652% harder than the North Carolina median (33 mg/L) 2nd hardest of 92 North Carolina towns Population 14,215 (2010)
248mg/L
14.5 grains per gallon
Very hard

Murraysville tap water at a glance

  • HardnessVery hard (248 mg/L, 14.5 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 248 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 14.5 gpg (13.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites97
Lab samples176
Sample years2000–2025
Middle 50% of sites170–313 mg/L
Groundwater (wells, springs)254 mg/L · 91 sites
Surface water (rivers, lakes)36 mg/L · 6 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Murraysville

Prefilled with Murraysville's measured local hardness of 248 mg/L (14.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Murraysville tap water

Murraysville is served by more than one water system. These systems supply ZIP codes in Murraysville and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Murraysville

Water systemPFAS detectedHighest PFOA / PFOSTested
Cfpua-Wilmington
serves over 10,000 people
PFPeA — Dec 2023 – Sep 2024
Pender County Utilities
serves over 10,000 people
PFPeA, PFBS, PFBA +1 more — Aug 2023 – May 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Murraysville

Murraysville is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Murraysville

Water systemService linesTotal
Cfpua-Wilmington0 lead · 0 galvanized · 0 unknown72,785
Pender County Utilities0 lead · 0 galvanized · 0 unknown11,300

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Murraysville drinking water violations

Murraysville is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Murraysville

Water systemHealth-based violationsMonitoring/reporting
Cfpua-WilmingtonNone4
Pender County Utilities169

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Murraysville

SiteTypeDistanceMedianSamplesYears
NH-564 NR WILMINGTON, NC PEEDEE
USGS North Carolina Water Science Center
Well 1.2 mi224 mg/L22012–2017
NH-548 NR WILMINGTON, NC CASTLE HAYNE
USGS North Carolina Water Science Center
Well 1.2 mi270 mg/L22012–2017
NH-582 NR WILMINGTON, NC PEEDEE
USGS North Carolina Water Science Center
Well 1.7 mi248 mg/L22012–2017
NH-572 NR WILMINGTON, NC PEEDEE
USGS North Carolina Water Science Center
Well 1.8 mi236 mg/L22012–2017
NH-556 NR WILMINGTON, NC CASTLE HAYNE
USGS North Carolina Water Science Center
Well 1.8 mi257 mg/L22012–2017
NH-845 NR WILMINGTON, NC PEEDEE
USGS North Carolina Water Science Center
Well 2.3 mi257 mg/L12012

Water hardness in towns near Murraysville

TownDistanceMedianClass
Wilmington6 mi 230 mg/LVery hard
Leland12 mi 41 mg/LSoft
Jacksonville40 mi 95 mg/LModerately hard
Piney Green45 mi 155 mg/LHard
Havelock69 mi 262 mg/LVery hard
Kinston69 mi 34 mg/LSoft
New Bern71 mi 178 mg/LHard
Lumberton71 mi 16 mg/LSoft
Goldsboro75 mi 30 mg/LSoft
Hope Mills79 mi 11 mg/LSoft

New Hanover County

Murraysville is in New Hanover County, where the median is 239 mg/L (very hard) across 102 sites.

See all of New Hanover County →

North Carolina

The statewide median is 33 mg/L (soft) from 1,749 sites.

North Carolina hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next