Water hardness in St. Louis, MO

Water in St. Louis is very hard, with a median of 237 mg/L (13.8 grains per gallon) across 21 monitoring sites within 10 miles.

13% harder than the Missouri median (209 mg/L) 49th hardest of 87 Missouri towns Population 281,754
237mg/L
13.8 grains per gallon
Very hard

Large city utilities sometimes soften, blend or import water from distant reservoirs, so tap water in St. Louis can differ from local source water. Your utility's annual Consumer Confidence Report lists the exact tap value.

St. Louis tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 237 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 13.8 gpg (13.3 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites21
Lab samples464
Sample years2000–2026
Middle 50% of sites218–370 mg/L
Surface water (rivers, lakes)237 mg/L · 21 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for St. Louis

Prefilled with St. Louis's measured local hardness of 237 mg/L (13.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in St. Louis tap water

ST Louis City PWS is the main public water system for St. Louis. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Mar 2024 – Dec 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of St. Louis

Water systemPFAS detectedHighest PFOA / PFOSTested
Mo American ST Louis ST Charles Counties
serves over 10,000 people
PFBA — Mar 2024 – Dec 2024
Thomas Hill PWSD 1
serves over 10,000 people
PFBA — Apr 2024 – Oct 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in St. Louis

ST Louis City PWS reported 105,873 service lines (the pipes connecting homes to the water main) in its inventory. 9,990 are lead and 525 are galvanized lines that must be replaced, and 64,378 are still of unknown material.

9,990lead (9%)
525galvanized requiring replacement
64,378unknown material (61%)
30,980not lead (29%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask ST Louis City PWS whether your address is on its list.

Other water systems serving parts of St. Louis

Water systemService linesTotal
Mo American ST Louis ST Charles Counties9,422 lead · 1,247 galvanized · 191,341 unknown388,276
Thomas Hill PWSD 10 lead · 0 galvanized · 2,653 unknown4,523

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

St. Louis drinking water violations

EPA records show no health-based violations for ST Louis City PWS since 2016. It also had 8 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of St. Louis

Water systemHealth-based violationsMonitoring/reporting
Mo American ST Louis ST Charles CountiesNone0
Thomas Hill PWSD 1None3

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to St. Louis

SiteTypeDistanceMedianSamplesYears
Mississippi River at St. Louis, MO
USGS Missouri Water Science Center
Stream 3.5 mi229 mg/L272004–2007
Engelholm Creek near Wellston, MO
USGS Missouri Water Science Center
Stream 4.5 mi218 mg/L302000–2004
River Des Peres near University City, MO
USGS Missouri Water Science Center
Stream 4.8 mi205 mg/L532000–2007
River des Peres @Heman Park
Midwest Envir. Consultants
River/Stream 4.8 mi250 mg/L192010–2011
Mississippi River above St. Louis at mm 184.5
USGS Missouri Water Science Center
Stream 4.9 mi224 mg/L262004–2007
Deer Creek at Maplewood, MO
USGS Missouri Water Science Center
Stream 5 mi239 mg/L232001–2004

Water hardness in towns near St. Louis

TownDistanceMedianClass
Clayton5 mi 256 mg/LVery hard
University City5 mi 266 mg/LVery hard
Jennings6 mi 276 mg/LVery hard
Webster Groves7 mi 250 mg/LVery hard
Lemay7 mi 237 mg/LVery hard
Affton7 mi 256 mg/LVery hard
Overland8 mi 294 mg/LVery hard
Bellefontaine Neighbors8 mi 288 mg/LVery hard
Ferguson8 mi 312 mg/LVery hard
Crestwood9 mi 256 mg/LVery hard

St. Louis city

St. Louis is in St. Louis city, where the median is 210 mg/L (very hard) across 2 sites.

See all of St. Louis city →

Missouri

The statewide median is 209 mg/L (very hard) from 1,834 sites.

Missouri hardness map →

St. Louis, MO water: common questions

Do I need a water softener in St. Louis?

Very likely. Water measured around St. Louis is 13.8 gpg (237 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 24,000 grains.Size it for your household →

Who supplies St. Louis's drinking water?

The main public water system serving St. Louis in EPA records is ST Louis City PWS. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in St. Louis?

It depends on what you want to remove. In St. Louis, the system reports 9,990 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next