Water hardness in Rogers, MN

Water in Rogers is very hard, with a median of 214 mg/L (12.5 grains per gallon) across 12 monitoring sites within 10 miles.

13% harder than the Minnesota median (190 mg/L) 66th hardest of 102 Minnesota towns Population 13,617
214mg/L
12.5 grains per gallon
Very hard

Rogers tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 214 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 12.5 gpg (12 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites12
Lab samples98
Sample years2002–2025
Middle 50% of sites190–292 mg/L
Groundwater (wells, springs)328 mg/L · 4 sites
Surface water (rivers, lakes)197 mg/L · 8 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Rogers

Prefilled with Rogers's measured local hardness of 214 mg/L (12.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Rogers tap water

The City of Rogers water system is the main public water system for Rogers. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 6 samples taken Apr 2025 – Nov 2025. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
8.6 ppt 2 of 6 samples —

Other water systems serving parts of Rogers

Water systemPFAS detectedHighest PFOA / PFOSTested
Maple Grove
serves over 10,000 people
PFBA — Jul 2023 – Apr 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Rogers

The City of Rogers water system reported 4,167 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 3 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
3unknown material (<1%)
4,164not lead (100%)

Other water systems serving parts of Rogers

Water systemService linesTotal
Maple Grove0 lead · 0 galvanized · 49 unknown25,292

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Rogers drinking water violations

EPA records show no health-based violations for the City of Rogers water system since 2016.

Other water systems serving parts of Rogers

Water systemHealth-based violationsMonitoring/reporting
Maple GroveNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Rogers

SiteTypeDistanceMedianSamplesYears
CROW R AT NEW CSAH-116 BRG, 2 MI E OF ST. MICHAEL
Minnesota Pollution Control Agency - Ambient Surface Water (State)
River/Stream 3.1 mi320 mg/L152008
UNN TRIB TO CROW R ON CSAH-19 AT ST. MICHAEL
Minnesota Pollution Control Agency - Ambient Surface Water (State)
River/Stream 4.8 mi204 mg/L122008
CROW RIVER AT BRIDGE ON CSAH-36 AT DAYTON
Minnesota Pollution Control Agency - Ambient Surface Water (State)
River/Stream 4.8 mi283 mg/L22002
MISSISSIPPI R. 2.5 MI DWNST OF HWY MN-101, 4.2 MI W OF RAMSEY, MN, TWP 121, RNG 23, SEC 25
Minnesota Pollution Control Agency - Ambient Surface Water (State)
River/Stream Perennial 5.2 mi150 mg/L332013–2024
WEAVER
Minnesota Pollution Control Agency - Ambient Surface Water (State)
Lake 6.3 mi150 mg/L122010–2012
ELM CK AT ELM CK BRG, 1 MILE SW OF DAYTON
Minnesota Pollution Control Agency - Ambient Surface Water (State)
River/Stream 6.7 mi220 mg/L32020–2021

Water hardness in towns near Rogers

TownDistanceMedianClass
Dayton5 mi 322 mg/LVery hard
St. Michael6 mi 234 mg/LVery hard
Otsego6 mi 246 mg/LVery hard
Maple Grove7 mi 349 mg/LVery hard
Ramsey8 mi 265 mg/LVery hard
Anoka9 mi 334 mg/LVery hard
Champlin9 mi 344 mg/LVery hard
Elk River10 mi 178 mg/LHard
Brooklyn Park12 mi 292 mg/LVery hard
Andover12 mi 272 mg/LVery hard

Hennepin County

Rogers is in Hennepin County, where the median is 309 mg/L (very hard) across 103 sites.

See all of Hennepin County →

Minnesota

The statewide median is 190 mg/L (very hard) from 2,553 sites.

Minnesota hardness map →

Rogers, MN water: common questions

Do I need a water softener in Rogers?

Very likely. Water measured around Rogers is 12.5 gpg (214 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 22,000 grains.Size it for your household →

Who supplies Rogers's drinking water?

The main public water system serving Rogers in EPA records is Rogers. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Rogers?

It depends on what you want to remove. In Rogers, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next