Water hardness in Dayton, MN

Water in Dayton is very hard, with a median of 322 mg/L (18.8 grains per gallon) across 36 monitoring sites within 10 miles.

69% harder than the Minnesota median (190 mg/L) 17th hardest of 102 Minnesota towns Population 10,157
322mg/L
18.8 grains per gallon
Very hard

Dayton tap water at a glance

  • HardnessVery hard (322 mg/L, 18.8 gpg, local measurements). Water softeners are common at this level.Size a water softener →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 322 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 18.8 gpg (18 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites36
Lab samples188
Sample years2000–2025
Middle 50% of sites216–423 mg/L
Groundwater (wells, springs)401 mg/L · 22 sites
Surface water (rivers, lakes)197 mg/L · 14 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Dayton

Prefilled with Dayton's measured local hardness of 322 mg/L (18.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Dayton tap water

Dayton is served by more than one water system. These systems supply ZIP codes in Dayton and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.

Water systems serving Dayton

Water systemPFAS detectedHighest PFOA / PFOSTested
Maple Grove
serves over 10,000 people
PFBA — Jul 2023 – Apr 2024
Rogers
serves over 10,000 people
PFBA — Apr 2025 – Nov 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Dayton

Dayton is served by more than one water system. Their service line inventories, as reported to EPA:

Water systems serving Dayton

Water systemService linesTotal
Maple Grove0 lead · 0 galvanized · 49 unknown25,292
Rogers0 lead · 0 galvanized · 3 unknown4,167

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Dayton drinking water violations

Dayton is served by more than one water system. Health-based violations recorded by EPA since 2016:

Water systems serving Dayton

Water systemHealth-based violationsMonitoring/reporting
Maple GroveNone0
RogersNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Dayton

SiteTypeDistanceMedianSamplesYears
ELM CK AT ELM CK BRG, 1 MILE SW OF DAYTON
Minnesota Pollution Control Agency - Ambient Surface Water (State)
River/Stream 2.5 mi220 mg/L32020–2021
MISSISSIPPI R. AT US-169 BRIDGE AT ANOKA, MN
Minnesota Pollution Control Agency - Ambient Surface Water (State)
River/Stream 3.7 mi190 mg/L32023
RUM R AT PED. BRG JUST ABOVE CONFLUENCE WITH MISS. R.
Minnesota Pollution Control Agency - Ambient Surface Water (State)
River/Stream 3.9 mi190 mg/L132023–2025
CROW RIVER AT BRIDGE ON CSAH-36 AT DAYTON
Minnesota Pollution Control Agency - Ambient Surface Water (State)
River/Stream 4.5 mi283 mg/L22002
032N24W30CDDBCD01 Anoka 8 0000676405
USGS Minnesota Water Science Center
Well 5.2 mi235 mg/L12014
UC040IN 119N22W13BCBBDC01 Maple Grov3 0000160028
USGS Minnesota Water Science Center
Well 5.4 mi421 mg/L12004

Water hardness in towns near Dayton

TownDistanceMedianClass
Anoka4 mi 334 mg/LVery hard
Champlin4 mi 344 mg/LVery hard
Rogers5 mi 214 mg/LVery hard
Ramsey5 mi 265 mg/LVery hard
Maple Grove5 mi 349 mg/LVery hard
Coon Rapids8 mi 338 mg/LVery hard
Andover8 mi 272 mg/LVery hard
Brooklyn Park8 mi 292 mg/LVery hard
Otsego9 mi 246 mg/LVery hard
St. Michael11 mi 234 mg/LVery hard

Hennepin County

Dayton is in Hennepin County, where the median is 309 mg/L (very hard) across 103 sites.

See all of Hennepin County →

Minnesota

The statewide median is 190 mg/L (very hard) from 2,553 sites.

Minnesota hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next