Water hardness in West Melbourne, FL
Water in West Melbourne is very hard, with a median of 282 mg/L (16.5 grains per gallon) across 95 monitoring sites within 10 miles.
West Melbourne tap water at a glance
- HardnessVery hard (282 mg/L, 16.5 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFAS3 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesNo known lead lines; 1,367 lines are still of unknown material.Check your own pipe →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 282 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 16.5 gpg (15.8 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for West Melbourne
Prefilled with West Melbourne's measured local hardness of 282 mg/L (16.5 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in West Melbourne tap water
West Melbourne WTR SYS(Consec) is the main public water system for West Melbourne. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 3 samples taken Dec 2025 – Jun 2026. 3 PFAS were detected.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBA perfluorobutanoic acid | 8.5 ppt | 3 of 3 samples | — |
| PFBS perfluorobutane sulfonic acid | 4.3 ppt | 3 of 3 samples | — |
| PFPeA perfluoropentanoic acid | 3.4 ppt | 2 of 3 samples | — |
Other water systems serving parts of West Melbourne
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| City of Melbourne serves over 10,000 people | PFBA, PFBS, PFPeA | — | Feb 2023 – Jan 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in West Melbourne
West Melbourne WTR SYS(Consec) reported 9,927 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 1 are galvanized lines that must be replaced, and 1,367 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask West Melbourne WTR SYS(Consec) whether your address is on its list.
Other water systems serving parts of West Melbourne
| Water system | Service lines | Total |
|---|---|---|
| City of Melbourne | 0 lead · 0 galvanized · 28,363 unknown | 60,477 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
West Melbourne drinking water violations
EPA records show no health-based violations for West Melbourne WTR SYS(Consec) since 2016. It also had 14 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of West Melbourne
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| City of Melbourne | None | 2 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to West Melbourne
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| Melbourne Tillman Canal @ Minton Rd FL Dept. of Environmental Protection, Southeast District | Canal Drainage | 1.6 mi | 245 mg/L | 6 | 2003 |
| Z3CN6021 FL Dept. of Environmental Protection | Canal Drainage | 1.6 mi | 311 mg/L | 1 | 2012 |
| Palm Bay SA Well 52 AAH7571 USGS Florida Water Science Center | Well | 2 mi | 414 mg/L | 1 | 2019 |
| CRANE CREEK @ EVANS ROAD FL Dept. of Environmental Protection, Southeast District | River/Stream | 2.4 mi | 350 mg/L | 5 | 2003 |
| C69 lateral canal St. Johns River Water Management District | Canal Drainage | 2.4 mi | 294 mg/L | 37 | 2009–2011 |
| Upstream of C1 canal in C69 lateral canal St. Johns Water Management District (Florida) | Canal Drainage | 2.4 mi | 299 mg/L | 34 | 2000–2009 |
Water hardness in towns near West Melbourne
| Town | Distance | Median | Class |
|---|---|---|---|
| Melbourne | 4 mi | 279 mg/L | Very hard |
| Palm Bay | 6 mi | 296 mg/L | Very hard |
| Satellite Beach | 10 mi | 272 mg/L | Very hard |
| Viera East | 15 mi | 190 mg/L | Very hard |
| Merritt Island | 18 mi | 282 mg/L | Very hard |
| Rockledge | 19 mi | 239 mg/L | Very hard |
| Cocoa Beach | 19 mi | 234 mg/L | Very hard |
| Sebastian | 21 mi | 316 mg/L | Very hard |
| Cocoa | 23 mi | 242 mg/L | Very hard |
| Cape Canaveral | 24 mi | 250 mg/L | Very hard |
Brevard County
West Melbourne is in Brevard County, where the median is 250 mg/L (very hard) across 183 sites.
See all of Brevard County →West Melbourne, FL water: common questions
Do I need a water softener in West Melbourne?
Very likely. Water measured around West Melbourne is 16.5 gpg (282 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 29,000 grains.Size it for your household →
Who supplies West Melbourne's drinking water?
The main public water system serving West Melbourne in EPA records is West Melbourne WTR SYS(Consec). Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in West Melbourne?
It depends on what you want to remove. In West Melbourne, EPA testing found PFBA, PFBS and PFPeA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Which water filters remove PFAS?EPA tests found 3 PFAS in West Melbourne's main water system.
- How to tell if your home has a lead pipe1,367 service lines here are of unknown material.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.