Water hardness in Walton County, FL

Water in Walton County is soft, with a median of 7 mg/L (0.4 grains per gallon) across 29 monitoring sites.

94% softer than the Florida median (121 mg/L) 65th hardest of 67 counties
7mg/L
0.4 grains per gallon
Soft

Walton County water at a glance

  • HardnessSoft (7 mg/L, 0.4 gpg, local measurements). A water softener isn't needed.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 7 mg/L means at home

  • Water softener: A water softener is generally not needed. Soft water rarely causes scale.
  • Dishwasher: set the water hardness to about 0.4 gpg (0.4 °dH), which is the lowest hardness setting (or softener off).
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites29
Lab samples139
Sample years2001–2024
Middle 50% of sites4–27 mg/L
Groundwater (wells, springs)86 mg/L · 3 sites
Surface water (rivers, lakes)6 mg/L · 26 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Walton County

Prefilled with Walton County's measured local hardness of 7 mg/L (0.4 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Walton County on the Florida map

St. Lucie CountyHardee CountyFlagler CountyEscambia CountyGlades CountyCharlotte CountyBrevard CountyAlachua CountyPutnam CountyHighlands CountyJefferson CountyNassau CountyCalhoun CountyBay CountyColumbia CountyGulf CountySuwannee CountyTaylor CountyClay CountyPinellas CountySarasota CountyMadison CountyMartin CountyHamilton CountyBaker CountyCitrus CountyHernando CountyLeon CountyOkaloosa CountySanta Rosa CountySeminole CountyWakulla CountyOsceola CountyLake CountyHendry CountyIndian River CountyManatee CountyPalm Beach CountyDuval CountyOkeechobee CountyLafayette CountyPasco CountyCollier CountySt. Johns CountyLee CountyMonroe CountySumter CountyBroward CountyGilchrist CountyLiberty CountyGadsden CountyJackson CountyWashington CountyDixie CountyMiami-Dade CountyLevy CountyVolusia CountyBradford CountyFranklin CountyMarion CountyHillsborough CountyDeSoto CountyPolk CountyOrange CountyHolmes CountyUnion County

Cities and communities in Walton County

PlaceMedian mg/LClassBased on
Freeport 58 Soft 5 sites within 10 miles
DeFuniak Springs 4 Soft 9 sites within 10 miles
Miramar Beach (CDP) 6 Soft 4 sites within 10 miles
Paxton 7 Soft 3 sites within 10 miles

Water quality in Walton County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Freeport City of Freeport None detected 0 lead · 0 unknown None
DeFuniak Springs City of Defuniak Springs W/S None detected 0 lead · 0 unknown None
Miramar Beach South Walton Utility Company None detected 0 lead · 0 unknown None
Paxton City of Paxton Not tested 0 lead · 0 unknown None

Neighboring counties

Florida

The statewide median is 121 mg/L (hard) from 6,382 sites.

Florida hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next