Water hardness in Colton, CA

Water in Colton is very hard, with a median of 198 mg/L (11.6 grains per gallon) across 161 monitoring sites within 10 miles.

25% harder than the California median (158 mg/L) 273rd hardest of 484 California towns Population 53,357
198mg/L
11.6 grains per gallon
Very hard

Colton tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 198 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 11.6 gpg (11.1 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites161
Lab samples512
Sample years2000–2022
Middle 50% of sites146–344 mg/L
Groundwater (wells, springs)198 mg/L · 152 sites
Surface water (rivers, lakes)209 mg/L · 9 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Colton

Prefilled with Colton's measured local hardness of 198 mg/L (11.6 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Colton tap water

City of Colton is the main public water system for Colton. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 15 samples taken Jul 2023 – Feb 2025. 6 PFAS were detected. The highest PFOS and PFOA results were above EPA's drinking water limit (4 ppt).

ChemicalHighest resultDetected inEPA limit
PFOS
perfluorooctane sulfonic acid
18 ppt 5 of 15 samples 4 ppt
PFBS
perfluorobutane sulfonic acid
10 ppt 3 of 15 samples —
PFOA
perfluorooctanoic acid
5.9 ppt 2 of 15 samples 4 ppt
PFHxS
perfluorohexane sulfonic acid
5.1 ppt 5 of 15 samples 10 ppt*
PFPeA
perfluoropentanoic acid
4.5 ppt 2 of 15 samples —
PFHxA
perfluorohexanoic acid
3.5 ppt 2 of 15 samples —

Other water systems serving parts of Colton

Water systemPFAS detectedHighest PFOA / PFOSTested
San Bernardino City
serves over 10,000 people
PFBS, PFHxS, PFHxA +1 more — Apr 2024 – Oct 2024
City of Riverside
serves over 10,000 people
PFPeA, PFHxA, PFOS ND / 4 ppt Feb 2023 – Nov 2023
West Valley Water District
serves over 10,000 people
None detected — Jan 2023 – Oct 2023
City of Loma Linda
serves over 10,000 people
None detected — Feb 2024 – Aug 2024
Redlands City MUD-Water Div
serves over 10,000 people
PFOS, PFHxS, PFOA 4.3 / 5.8 ppt Aug 2023 – May 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Colton

City of Colton reported 12,120 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
12,120not lead (100%)

Other water systems serving parts of Colton

Water systemService linesTotal
San Bernardino City0 lead · 0 galvanized · 0 unknown42,057
City of Riverside0 lead · 0 galvanized · 0 unknown68,071
West Valley Water District0 lead · 0 galvanized · 0 unknown25,174
City of Loma Linda0 lead · 0 galvanized · 0 unknown6,370
Redlands City MUD-Water Div0 lead · 0 galvanized · 0 unknown22,749

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Colton drinking water violations

EPA records show no health-based violations for City of Colton since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Colton

Water systemHealth-based violationsMonitoring/reporting
San Bernardino CityNone0
City of RiversideNone0
West Valley Water DistrictNone0
City of Loma LindaNone1
Redlands City MUD-Water DivNone0

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Colton

SiteTypeDistanceMedianSamplesYears
001S004W29K002S
USGS California Water Science Center
Well 0.4 mi123 mg/L22002–2007
001S004W29K004S
USGS California Water Science Center
Well 0.4 mi156 mg/L32002–2007
001S004W29K003S
USGS California Water Science Center
Well 0.4 mi271 mg/L32002–2007
001S004W29K001S
USGS California Water Science Center
Well 0.4 mi15 mg/L22002–2007
001S004W29K005S
USGS California Water Science Center
Well 0.4 mi178 mg/L22002–2007
001S004W29H004S
USGS California Water Science Center
Well 0.6 mi7 mg/L32002–2007

Water hardness in towns near Colton

TownDistanceMedianClass
Grand Terrace2 mi 212 mg/LVery hard
Bloomington4 mi 245 mg/LVery hard
Loma Linda4 mi 164 mg/LHard
Rialto6 mi 198 mg/LVery hard
San Bernardino6 mi 157 mg/LHard
Muscoy7 mi 159 mg/LHard
Fontana9 mi 240 mg/LVery hard
Redlands9 mi 168 mg/LHard
Jurupa Valley9 mi 302 mg/LVery hard
Riverside9 mi 400 mg/LVery hard

San Bernardino County

Colton is in San Bernardino County, where the median is 126 mg/L (hard) across 1057 sites.

See all of San Bernardino County →

California

The statewide median is 158 mg/L (hard) from 5,772 sites.

California hardness map →

Colton, CA water: common questions

Do I need a water softener in Colton?

Very likely. Water measured around Colton is 11.6 gpg (198 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 20,000 grains.Size it for your household →

Who supplies Colton's drinking water?

The main public water system serving Colton in EPA records is City of Colton. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Colton?

It depends on what you want to remove. In Colton, EPA testing found PFOS, PFBS and PFOA and 3 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next