Water hardness in Howard, WI

Water in Howard is very hard, with a median of 187 mg/L (10.9 grains per gallon) across 9 monitoring sites within 10 miles.

26% harder than the Wisconsin median (148 mg/L) 73rd hardest of 97 Wisconsin towns Population 20,775
187mg/L
10.9 grains per gallon
Very hard

Howard tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 187 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 10.9 gpg (10.5 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites9
Lab samples145
Sample years2000–2020
Middle 50% of sites161–262 mg/L
Groundwater (wells, springs)262 mg/L · 1 sites
Surface water (rivers, lakes)186 mg/L · 8 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Howard

Prefilled with Howard's measured local hardness of 187 mg/L (10.9 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Howard tap water

Howard Waterworks is the main public water system for Howard. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Jan 2023 – Jan 2024. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Howard

Water systemPFAS detectedHighest PFOA / PFOSTested
Green Bay Waterworks
serves over 10,000 people
None detected — Jan 2024 – Oct 2024
Ashwaubenon Waterworks
serves over 10,000 people
None detected — Feb 2023 – Nov 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Howard

Howard Waterworks reported 6,841 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 3,908 lines are still of unknown material.

0lead (0%)
0galvanized requiring replacement
3,908unknown material (57%)
2,933not lead (43%)

Other water systems serving parts of Howard

Water systemService linesTotal
Green Bay Waterworks4 lead · 68 galvanized · 0 unknown34,412
Ashwaubenon Waterworks0 lead · 0 galvanized · 0 unknown7,279

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Howard drinking water violations

EPA records show 2 health-based violations for Howard Waterworks since 2016, all since resolved or closed. The most recent began in Oct 2024. It also had 3 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Contaminant or ruleTypeViolationsMost recentStatus
Lead and Copper Rule Revisions
lead service line inventory and lead rule requirements
Treatment requirement not met 1 Oct 2024 Resolved/closed
Groundwater Rule
requirements to protect well water from fecal contamination
Treatment requirement not met 1 Dec 2023 Resolved/closed

Other water systems serving parts of Howard

Water systemHealth-based violationsMonitoring/reporting
Green Bay WaterworksNone4
Ashwaubenon WaterworksNone1

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Howard

SiteTypeDistanceMedianSamplesYears
LANCASTER BROOK AT SHAWANO AVENUE AT HOWARD, WI
USGS Wisconsin Water Science Center
Stream 1.7 mi161 mg/L12002
St Marys Inlet Pipe At Green Bay WI
Wisconsin Department of Natural Resources
River/Stream 2.4 mi78 mg/L272000–2002
ST. MARY'S HOSPITAL FILTER PIPE - GREEN BAY
Wisconsin Department of Natural Resources
River/Stream 2.4 mi160 mg/L192001–2002
TROUT CREEK NEAR HOWARD, WI
USGS Wisconsin Water Science Center
Stream 3.7 mi185 mg/L12002
DUCK CREEK NEAR HOWARD, WI
USGS Wisconsin Water Science Center
Stream 3.7 mi392 mg/L432000–2016
FOX RIVER AT OIL TANK DEPOT AT GREEN BAY, WI
USGS Wisconsin Water Science Center
Stream 4.1 mi187 mg/L172011–2020

Water hardness in towns near Howard

TownDistanceMedianClass
Suamico4 mi 186 mg/LVery hard
Green Bay5 mi 186 mg/LVery hard
Ashwaubenon6 mi 188 mg/LVery hard
Hobart7 mi 188 mg/LVery hard
Allouez7 mi 188 mg/LVery hard
Bellevue9 mi 188 mg/LVery hard
De Pere10 mi 225 mg/LVery hard
Kaukauna22 mi 310 mg/LVery hard
Little Chute23 mi 310 mg/LVery hard
Appleton25 mi 180 mg/LHard

Brown County

Howard is in Brown County, where the median is 262 mg/L (very hard) across 13 sites.

See all of Brown County →

Wisconsin

The statewide median is 148 mg/L (hard) from 1,102 sites.

Wisconsin hardness map →

Howard, WI water: common questions

Do I need a water softener in Howard?

Very likely. Water measured around Howard is 10.9 gpg (187 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 19,000 grains.Size it for your household →

Who supplies Howard's drinking water?

The main public water system serving Howard in EPA records is Howard Waterworks. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Howard?

It depends on what you want to remove. In Howard, the system had 2 health-based violations since 2016, for the Lead and Copper Rule Revisions and the Groundwater Rule; the utility's annual report says what was done about them. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next