Water hardness in Beaver Dam, WI

Water in Beaver Dam is very hard, with a median of 334 mg/L (19.5 grains per gallon) across Dodge County.

126% harder than the Wisconsin median (148 mg/L) 17th hardest of 97 Wisconsin towns Population 16,531
334mg/L
19.5 grains per gallon
Very hard

There are not enough monitoring sites within 10 miles of Beaver Dam, so this page uses the Dodge County median.

Beaver Dam tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 334 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 19.5 gpg (18.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites1
Lab samples1
Sample years2014–2014
Middle 50% of sites334–334 mg/L
Groundwater (wells, springs)334 mg/L · 1 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Beaver Dam

Prefilled with Beaver Dam's measured local hardness of 334 mg/L (19.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Beaver Dam tap water

Beaver Dam Water Utility is the main public water system for Beaver Dam. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 2 samples taken Apr 2023 – Oct 2023. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Beaver Dam

Beaver Dam Water Utility reported 5,671 service lines (the pipes connecting homes to the water main) in its inventory. 1,072 are lead and 99 are galvanized lines that must be replaced, and 4 are still of unknown material.

1,072lead (19%)
99galvanized requiring replacement
4unknown material (<1%)
4,496not lead (79%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Beaver Dam Water Utility whether your address is on its list.

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Beaver Dam drinking water violations

EPA records show no health-based violations for Beaver Dam Water Utility since 2016.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Water hardness in towns near Beaver Dam

TownDistanceMedianClass
Waupun12 mi 334 mg/LVery hard
Watertown20 mi 246 mg/LVery hard
Hartford25 mi 304 mg/LVery hard
Sun Prairie28 mi 388 mg/LVery hard
Fond du Lac29 mi 395 mg/LVery hard
Oconomowoc31 mi 250 mg/LVery hard
DeForest31 mi 378 mg/LVery hard
Portage32 mi 254 mg/LVery hard
West Bend33 mi 304 mg/LVery hard
Richfield34 mi 266 mg/LVery hard

Dodge County

Beaver Dam is in Dodge County, where the median is 334 mg/L (very hard) across 1 sites.

See all of Dodge County →

Wisconsin

The statewide median is 148 mg/L (hard) from 1,102 sites.

Wisconsin hardness map →

Beaver Dam, WI water: common questions

Do I need a water softener in Beaver Dam?

Very likely. Water measured around Beaver Dam is 19.5 gpg (334 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 34,000 grains.Size it for your household →

Who supplies Beaver Dam's drinking water?

The main public water system serving Beaver Dam in EPA records is Beaver Dam Water Utility. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Beaver Dam?

It depends on what you want to remove. In Beaver Dam, the system reports 1,072 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next