Water hardness in Franklin County, VT

Water in Franklin County is moderately hard, with a median of 85 mg/L (4.9 grains per gallon) across 169 monitoring sites.

47% harder than the Vermont median (58 mg/L) 4th hardest of 14 counties
85mg/L
4.9 grains per gallon
Moderately hard

Franklin County water at a glance

  • HardnessModerately hard (85 mg/L, 4.9 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 85 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 4.9 gpg (4.8 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites169
Lab samples955
Sample years2000–2025
Middle 50% of sites50–150 mg/L
Groundwater (wells, springs)184 mg/L · 1 sites
Surface water (rivers, lakes)84 mg/L · 168 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Franklin County

Prefilled with Franklin County's measured local hardness of 85 mg/L (5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Franklin County on the Vermont map

Washington CountyEssex CountyAddison CountyGrand Isle CountyWindsor CountyOrange CountyBennington CountyLamoille CountyCaledonia CountyChittenden CountyRutland CountyOrleans CountyWindham County

Cities and communities in Franklin County

PlaceMedian mg/LClassBased on
St. Albans 148 Hard 67 sites within 10 miles
Swanton 153 Hard 64 sites within 10 miles
Richford (CDP) 46 Soft 45 sites within 10 miles
Enosburg Falls 65 Moderately hard 78 sites within 10 miles
Bakersfield (CDP) 60 Soft 53 sites within 10 miles
Fairfax (CDP) 97 Moderately hard 77 sites within 10 miles
Highgate Center (CDP) 116 Moderately hard 75 sites within 10 miles
Highgate Springs (CDP) 128 Hard 51 sites within 10 miles

Water quality in Franklin County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
St. Albans ST Albans Water Dept None detected Not reported 1
Swanton Swanton Village Water Not tested 3 lead · 0 unknown None
Richford Richford Water System Not tested 0 lead · 504 unknown 2
Enosburg Falls Enosburg Falls Water System Not tested 0 lead · 170 unknown None
Bakersfield Bakersfield Fire District 1 Not tested 0 lead · 106 unknown None
Fairfax Fairfax Water Dept Not tested 0 lead · 0 unknown None

Neighboring counties

Vermont

The statewide median is 58 mg/L (soft) from 2,339 sites.

Vermont hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next