Water hardness in St. George, UT
Groundwater and surface water around St. George measure a median of 618 mg/L (36.1 grains per gallon). St. George's water utility may treat, blend or import its water, so the water at your tap can be much softer than this.
This is not a tap water measurement. We have not yet confirmed the hardness St. George's utility delivers. Check the utility's annual Consumer Confidence Report or your water bill for the exact figure before choosing a softener setting.
St. George tap water at a glance
- HardnessTap water figure not published yet; local source water is very hard and the utility may treat it.Find it in your water report →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- ViolationsNo health-based violations since 2016.EPA record →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
Hard water at home in St. George
- Water softener and dishwasher: first find your tap water hardness in your utility's report, then use our softener calculator. Divide mg/L by 17.1 to get grains per gallon for the dishwasher setting.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Do you need a softener? Size calculator → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
PFAS in St. George tap water
ST George City Water System is the main public water system for St. George. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 18 samples taken Jan 2024 – Oct 2024. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of St. George
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Washington City serves over 10,000 people | None detected | — | Oct 2023 – Jul 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in St. George
ST George City Water System reported 44,972 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of St. George
| Water system | Service lines | Total |
|---|---|---|
| Washington City | 0 lead · 8 galvanized · 0 unknown | 14,614 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
St. George drinking water violations
EPA records show no health-based violations for ST George City Water System since 2016. It also had 10 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
Other water systems serving parts of St. George
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Washington City | None | 15 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to St. George
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| SANTA CLARA R AB VIRGIN RIVER Utah Department Of Environmental Quality | River/Stream | 0.4 mi | 1159 mg/L | 48 | 2000–2013 |
| VIRGIN RIVER NEAR BLOOMINGTON, UT USGS Utah Water Science Center | Stream | 0.6 mi | 618 mg/L | 2 | 2009–2010 |
| VIRGIN R SE OF ST GEORGE @ CR XING Utah Department Of Environmental Quality | River/Stream | 1.3 mi | 919 mg/L | 40 | 2001–2013 |
| VIRGIN R SE OF ST GEORGE @ CR XING Replicate of 4950200 Utah Department Of Environmental Quality | River/Stream | 1.3 mi | 925 mg/L | 14 | 2001–2013 |
| (C-42-15)34bbc Drain 1 nr. Washington USGS Utah Water Science Center | Stream: Ditch | 2.7 mi | 1100 mg/L | 3 | 2010 |
| (C-42-16)26bcc- 1 USGS Utah Water Science Center | Well | 3.1 mi | 1585 mg/L | 2 | 2007–2020 |
Water hardness in towns near St. George
| Town | Distance | Median | Class |
|---|---|---|---|
| Washington | 6 mi | 314 mg/L | Very hard |
| Ivins | 9 mi | 258 mg/L | Very hard |
| Hurricane | 13 mi | 278 mg/L | Very hard |
| Cedar City | 50 mi | 494 mg/L | Very hard |
| Santaquin | 222 mi | 334 mg/L | Very hard |
| Payson | 227 mi | 299 mg/L | Very hard |
| Salem | 230 mi | 289 mg/L | Very hard |
| Spanish Fork | 234 mi | 294 mg/L | Very hard |
| Mapleton | 236 mi | 288 mg/L | Very hard |
| Springville | 238 mi | 292 mg/L | Very hard |
Washington County
St. George is in Washington County, where the median is 247 mg/L (very hard) across 170 sites.
See all of Washington County →St. George, UT water: common questions
Who supplies St. George's drinking water?
The main public water system serving St. George in EPA records is ST George City Water System. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in St. George?
Not for anything in EPA's records: no PFAS found in EPA testing, no lead service lines reported and no health-based violations since 2016. People here who use a filter usually do it for taste, such as chlorine.Chlorine taste in tap water →
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.