Water hardness in Roy, UT
Water in Roy is very hard, with a median of 244 mg/L (14.3 grains per gallon) across 45 monitoring sites within 10 miles.
Roy tap water at a glance
- HardnessVery hard (244 mg/L, 14.3 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- Violations1 health-based violation since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 244 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 14.3 gpg (13.7 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Roy
Prefilled with Roy's measured local hardness of 244 mg/L (14.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Roy tap water
Roy City Water System is the main public water system for Roy. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 12 samples taken Jan 2024 – Oct 2024. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Roy
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Hooper Water Improvement District serves over 10,000 people | None detected | — | Sep 2023 – Mar 2024 |
| Ogden City Water System serves over 10,000 people | None detected | — | Jan 2024 – Jun 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Roy
Roy City Water System reported 11,111 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Roy
| Water system | Service lines | Total |
|---|---|---|
| Hooper Water Improvement District | 0 lead · 0 galvanized · 0 unknown | 7,338 |
| Ogden City Water System | 0 lead · 0 galvanized · 0 unknown | 25,572 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Roy drinking water violations
EPA records show 1 health-based violation for Roy City Water System since 2016, all since resolved or closed. The most recent began in Sep 2017. It also had 62 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Groundwater Rule requirements to protect well water from fecal contamination | Treatment requirement not met | 1 | Sep 2017 | Resolved/closed |
Other water systems serving parts of Roy
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Hooper Water Improvement District | 1 | 8 |
| Ogden City Water System | None | 1 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Roy
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| Weber River Bl bridge at Riverdale Road xing (UT09ST-548) Utah Department Of Environmental Quality | River/Stream | 3 mi | 285 mg/L | 1 | 2013 |
| (B- 5- 2) 6cdd- 2 USGS Utah Water Science Center | Well | 3.7 mi | 124 mg/L | 3 | 2011–2019 |
| (B- 5- 1)30ada- 2 USGS Utah Water Science Center | Well | 3.7 mi | 247 mg/L | 1 | 2008 |
| (B- 5- 2) 6bdd- 5 USGS Utah Water Science Center | Well | 3.9 mi | 234 mg/L | 4 | 2008–2016 |
| (B- 5- 2) 6bdd- 1 USGS Utah Water Science Center | Well | 3.9 mi | 143 mg/L | 3 | 2007–2017 |
| (B- 5- 2) 6bdd- 4 USGS Utah Water Science Center | Well | 3.9 mi | 148 mg/L | 6 | 2009–2021 |
Water hardness in towns near Roy
| Town | Distance | Median | Class |
|---|---|---|---|
| Clinton | 2 mi | 244 mg/L | Very hard |
| West Haven | 3 mi | 234 mg/L | Very hard |
| West Point | 4 mi | 262 mg/L | Very hard |
| South Ogden | 5 mi | 203 mg/L | Very hard |
| Clearfield | 5 mi | 254 mg/L | Very hard |
| Ogden | 6 mi | 195 mg/L | Very hard |
| Syracuse | 6 mi | 267 mg/L | Very hard |
| Layton | 8 mi | 253 mg/L | Very hard |
| Pleasant View | 11 mi | 209 mg/L | Very hard |
| North Ogden | 11 mi | 188 mg/L | Very hard |
Weber County
Roy is in Weber County, where the median is 195 mg/L (very hard) across 70 sites.
See all of Weber County →Roy, UT water: common questions
Do I need a water softener in Roy?
Very likely. Water measured around Roy is 14.3 gpg (244 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 25,000 grains.Size it for your household →
Who supplies Roy's drinking water?
The main public water system serving Roy in EPA records is Roy City Water System. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Roy?
It depends on what you want to remove. In Roy, the system had 1 health-based violation since 2016, for the Groundwater Rule; the utility's annual report says what was done about it. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.