Water hardness in Mount Pleasant, TX

Water in Mount Pleasant is moderately hard, with a median of 100 mg/L (5.8 grains per gallon) across 3 monitoring sites within 10 miles.

48% softer than the Texas median (194 mg/L) 223rd hardest of 251 Texas towns Population 16,055
100mg/L
5.8 grains per gallon
Moderately hard

Mount Pleasant tap water at a glance

  • HardnessModerately hard (100 mg/L, 5.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
  • Lead pipesNo known lead lines; 530 lines are still of unknown material.Check your own pipe →
  • ViolationsNo health-based violations since 2016.EPA record →

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 100 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.8 gpg (5.6 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites3
Lab samples26
Sample years2000–2003
Middle 50% of sites70–175 mg/L
Surface water (rivers, lakes)100 mg/L · 3 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Mount Pleasant

Prefilled with Mount Pleasant's measured local hardness of 100 mg/L (5.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Mount Pleasant tap water

City of Mount Pleasant is the main public water system for Mount Pleasant. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 4 samples taken Feb 2024 – Jul 2025. 1 PFAS was detected.

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
12.3 ppt 2 of 4 samples —

Other water systems serving parts of Mount Pleasant

Water systemPFAS detectedHighest PFOA / PFOSTested
Tri Sud
serves over 10,000 people
PFBA — Jul 2023 – Apr 2024

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Mount Pleasant

City of Mount Pleasant reported 6,000 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 406 are galvanized lines that must be replaced, and 530 are still of unknown material.

0lead (0%)
406galvanized requiring replacement
530unknown material (9%)
5,064not lead (84%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Mount Pleasant whether your address is on its list.

Other water systems serving parts of Mount Pleasant

Water systemService linesTotal
Tri Sud0 lead · 0 galvanized · 0 unknown6,502

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Mount Pleasant drinking water violations

EPA records show no health-based violations for City of Mount Pleasant since 2016. It also had 6 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Mount Pleasant

Water systemHealth-based violationsMonitoring/reporting
Tri SudNone3

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Mount Pleasant

SiteTypeDistanceMedianSamplesYears
TANKERSLEY CREEK AT FM3417
Texas Commission on Environmental Quality
River/Stream 4.3 mi250 mg/L42002–2003
WALKERS CREEK AT BIG CYPRESS C
Texas Commission on Environmental Quality
River/Stream 7.9 mi40 mg/L192000–2001
BLUNDELL CREEK AT CR 4130
Texas Commission on Environmental Quality
River/Stream 9.3 mi100 mg/L32003

Water hardness in towns near Mount Pleasant

TownDistanceMedianClass
Sulphur Springs37 mi 76 mg/LModerately hard
Longview46 mi 50 mg/LSoft
Paris48 mi 57 mg/LSoft
Kilgore53 mi 48 mg/LSoft
Texarkana55 mi 49 mg/LSoft
Marshall56 mi 28 mg/LSoft
Tyler61 mi 62 mg/LModerately hard
Greenville66 mi 78 mg/LModerately hard
Henderson70 mi 10 mg/LSoft
Bonham76 mi 96 mg/LModerately hard

Titus County

Mount Pleasant is in Titus County, where the median is 104 mg/L (moderately hard) across 4 sites.

See all of Titus County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Mount Pleasant, TX water: common questions

Do I need a water softener in Mount Pleasant?

Probably not. Water measured around Mount Pleasant is 5.8 gpg (100 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 10,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →

Who supplies Mount Pleasant's drinking water?

The main public water system serving Mount Pleasant in EPA records is City of Mount Pleasant. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Mount Pleasant?

It depends on what you want to remove. In Mount Pleasant, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next