Water hardness in Brownsville, TX

Water in Brownsville is very hard, with a median of 346 mg/L (20.2 grains per gallon) across Cameron County.

78% harder than the Texas median (194 mg/L) 25th hardest of 251 Texas towns Population 190,158
346mg/L
20.2 grains per gallon
Very hard

Large city utilities sometimes soften, blend or import water from distant reservoirs, so tap water in Brownsville can differ from local source water. Your utility's annual Consumer Confidence Report lists the exact tap value.

There are not enough monitoring sites within 10 miles of Brownsville, so this page uses the Cameron County median.

Brownsville tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 346 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 20.2 gpg (19.4 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites5
Lab samples336
Sample years2000–2023
Middle 50% of sites330–791 mg/L
Groundwater (wells, springs)346 mg/L · 1 sites
Surface water (rivers, lakes)560 mg/L · 4 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Brownsville

Prefilled with Brownsville's measured local hardness of 346 mg/L (20.2 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Brownsville tap water

Brownsville Public Utilities Board is the main public water system for Brownsville. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 8 samples taken Jul 2024 – Jun 2025. 7 PFAS were detected. The highest PFOS and PFOA results were above EPA's drinking water limit (4 ppt).

ChemicalHighest resultDetected inEPA limit
PFBA
perfluorobutanoic acid
9.3 ppt 7 of 8 samples —
PFOS
perfluorooctane sulfonic acid
9.2 ppt 7 of 8 samples 4 ppt
PFHxA
perfluorohexanoic acid
8 ppt 8 of 8 samples —
PFPeA
perfluoropentanoic acid
7.6 ppt 8 of 8 samples —
PFOA
perfluorooctanoic acid
4.7 ppt 1 of 8 samples 4 ppt
PFHxS
perfluorohexane sulfonic acid
4.4 ppt 8 of 8 samples 10 ppt*
PFHpA
perfluoroheptanoic acid
4.1 ppt 2 of 8 samples —

Other water systems serving parts of Brownsville

Water systemPFAS detectedHighest PFOA / PFOSTested
East Rio Hondo WSC
serves over 10,000 people
PFBA, PFPeA, PFHxA +5 more 5.4 / 5.6 ppt Jul 2024 – Apr 2026
Laguna Madre Water District
serves over 10,000 people
PFBA, PFPeA, PFHxA — Feb 2023 – Mar 2024
City of San Benito
serves over 10,000 people
PFBA, PFHxA, PFPeA +3 more ND / 4.8 ppt Feb 2025 – Dec 2025

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Brownsville

Brownsville Public Utilities Board reported 59,853 service lines (the pipes connecting homes to the water main) in its inventory. 0 are lead and 6 are galvanized lines that must be replaced, and 17,503 are still of unknown material.

0lead (0%)
6galvanized requiring replacement
17,503unknown material (29%)
42,344not lead (71%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Brownsville Public Utilities Board whether your address is on its list.

Other water systems serving parts of Brownsville

Water systemService linesTotal
East Rio Hondo WSC0 lead · 0 galvanized · 0 unknown8,962
Laguna Madre Water District0 lead · 0 galvanized · 0 unknown7,807
City of San Benito0 lead · 0 galvanized · 60 unknown60

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Brownsville drinking water violations

EPA records show no health-based violations for Brownsville Public Utilities Board since 2016.

Other water systems serving parts of Brownsville

Water systemHealth-based violationsMonitoring/reporting
East Rio Hondo WSC10
Laguna Madre Water DistrictNone3
City of San Benito14

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Brownsville

SiteTypeDistanceMedianSamplesYears
RIO GRANDE AT EL JARDIN PUMP
Texas Commission on Environmental Quality
River/Stream 8.1 mi300 mg/L182002–2004
Rio Grande nr Brownsville, TX
USGS Texas Water Science Center
Stream 8.2 mi330 mg/L2302000–2023

Water hardness in towns near Brownsville

TownDistanceMedianClass
San Benito15 mi 791 mg/LVery hard
Harlingen20 mi 346 mg/LVery hard
Mercedes31 mi 232 mg/LVery hard
Weslaco35 mi 232 mg/LVery hard
Donna38 mi 232 mg/LVery hard
Alamo43 mi 232 mg/LVery hard
San Juan46 mi 232 mg/LVery hard
Pharr47 mi 232 mg/LVery hard
Edinburg50 mi 232 mg/LVery hard
Hidalgo50 mi 232 mg/LVery hard

Cameron County

Brownsville is in Cameron County, where the median is 346 mg/L (very hard) across 5 sites.

See all of Cameron County →

Texas

The statewide median is 194 mg/L (very hard) from 2,271 sites.

Texas hardness map →

Brownsville, TX water: common questions

Do I need a water softener in Brownsville?

Very likely. Water measured around Brownsville is 20.2 gpg (346 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 35,000 grains.Size it for your household →

Who supplies Brownsville's drinking water?

The main public water system serving Brownsville in EPA records is Brownsville Public Utilities Board. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Brownsville?

It depends on what you want to remove. In Brownsville, EPA testing found PFBA, PFOS and PFHxA and 4 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS. On the other hand, no lead service lines reported and no health-based violations since 2016. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next