Water hardness in Clay County, TN
Water in Clay County is moderately hard, with a median of 105 mg/L (6.1 grains per gallon) across 17 monitoring sites.
Clay County water at a glance
- HardnessModerately hard (105 mg/L, 6.1 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 105 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.1 gpg (5.9 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Clay County
Prefilled with Clay County's measured local hardness of 105 mg/L (6.1 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Clay County on the Tennessee map
Cities and communities in Clay County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Celina | 104 | Moderately hard | 16 sites within 10 miles |
Water quality in Clay County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Celina | Celina Water System | None detected | 0 lead · 1 unknown | None |
Neighboring counties
- Jackson County108 mg/L
- Overton County147 mg/L
- Macon County108 mg/L
- Pickett County103 mg/L
- Putnam County150 mg/L
- Smith County86 mg/L
Tennessee
The statewide median is 98 mg/L (moderately hard) from 3,359 sites.
Tennessee hardness map →Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.