Water hardness in Washington, PA
Water in Washington is very hard, with a median of 225 mg/L (13.1 grains per gallon) across 3 monitoring sites within 10 miles.
Washington tap water at a glance
- HardnessVery hard (225 mg/L, 13.1 gpg, local measurements). Water softeners are common at this level.Size a water softener →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 225 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 13.1 gpg (12.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Washington
Prefilled with Washington's measured local hardness of 225 mg/L (13.2 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Washington tap water
Washington is served by more than one water system. These systems supply ZIP codes in Washington and were tested for PFAS ("forever chemicals") in EPA's nationwide UCMR 5 study. Check your water bill to see which one is yours.
Water systems serving Washington
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Pa Amer Water Co-Pittsburgh serves over 10,000 people | None detected | — | Jan 2024 – Oct 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Washington
Washington is served by more than one water system. Their service line inventories, as reported to EPA:
Water systems serving Washington
| Water system | Service lines | Total |
|---|---|---|
| Pa Amer Water Co-Pittsburgh | 4,290 lead · 1,780 galvanized · 207,101 unknown | 230,084 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Washington drinking water violations
Washington is served by more than one water system. Health-based violations recorded by EPA since 2016:
Water systems serving Washington
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Pa Amer Water Co-Pittsburgh | 1 | 2 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Washington
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| Canonsburg Lake Station 1 PA DEPARTMENT OF ENVIRONMENTAL PROTECTION | River/Stream | 8.9 mi | 225 mg/L | 7 | 2021 |
| Canonsburg Lake Station 2 PA DEPARTMENT OF ENVIRONMENTAL PROTECTION | River/Stream | 9 mi | 227 mg/L | 7 | 2021 |
| Cross Creek Lake Station 2 Mid-lake PA DEPARTMENT OF ENVIRONMENTAL PROTECTION | River/Stream | 9.9 mi | 161 mg/L | 6 | 2022 |
Water hardness in towns near Washington
| Town | Distance | Median | Class |
|---|---|---|---|
| Bethel Park | 15 mi | 351 mg/L | Very hard |
| Jefferson Hills | 18 mi | 254 mg/L | Very hard |
| Whitehall | 19 mi | 316 mg/L | Very hard |
| Baldwin | 21 mi | 258 mg/L | Very hard |
| West Mifflin | 22 mi | 286 mg/L | Very hard |
| Pittsburgh | 23 mi | 230 mg/L | Very hard |
| Munhall | 24 mi | 224 mg/L | Very hard |
| Carnot-Moon | 24 mi | 359 mg/L | Very hard |
| McKeesport | 24 mi | 210 mg/L | Very hard |
| Wilkinsburg | 27 mi | 212 mg/L | Very hard |
Washington County
Washington is in Washington County, where the median is 174 mg/L (hard) across 45 sites.
See all of Washington County →Pennsylvania
The statewide median is 82 mg/L (moderately hard) from 4,757 sites.
Pennsylvania hardness map →Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Hard water and your water heaterHow scale affects your water heater and how often to flush.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.