Water hardness in Kent, OH

Water in Kent is very hard, with a median of 211 mg/L (12.3 grains per gallon) across 113 monitoring sites within 10 miles.

24% softer than the Ohio median (276 mg/L) 140th hardest of 183 Ohio towns Population 27,601
211mg/L
12.3 grains per gallon
Very hard

Kent tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 211 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 12.3 gpg (11.8 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites113
Lab samples1,008
Sample years2000–2020
Middle 50% of sites169–266 mg/L
Groundwater (wells, springs)382 mg/L · 3 sites
Surface water (rivers, lakes)209 mg/L · 110 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Kent

Prefilled with Kent's measured local hardness of 211 mg/L (12.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Kent tap water

Kent City PWS is the main public water system for Kent. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 2 samples taken Feb 2025 – Aug 2025. No PFAS were found at or above EPA's minimum reporting levels.

Other water systems serving parts of Kent

Water systemPFAS detectedHighest PFOA / PFOSTested
Akron City PWS
serves over 10,000 people
PFOA, PFBA 7.3 / ND ppt Mar 2023 – Dec 2023

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Kent

Kent City PWS reported 6,664 service lines (the pipes connecting homes to the water main) in its inventory. 1 are lead and 64 are galvanized lines that must be replaced, and 2,508 are still of unknown material.

1lead (<1%)
64galvanized requiring replacement
2,508unknown material (38%)
4,091not lead (61%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask Kent City PWS whether your address is on its list.

Other water systems serving parts of Kent

Water systemService linesTotal
Akron City PWS1,683 lead · 7,389 galvanized · 5,490 unknown89,061

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Kent drinking water violations

EPA records show no health-based violations for Kent City PWS since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Other water systems serving parts of Kent

Water systemHealth-based violationsMonitoring/reporting
Akron City PWS13

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Kent

SiteTypeDistanceMedianSamplesYears
CUYAHOGA R. AT KENT @ STOW ST.
Division of Surface water (Ohio) (State)
River/Stream 0.2 mi156 mg/L142005–2020
PLUM CREEK DST. KENT WTP @ CHERRY ST.
Division of Surface water (Ohio) (State)
River/Stream 0.7 mi229 mg/L312000–2018
CUYAHOGA R. AT KENT @ CRAIN AVE.
Division of Surface water (Ohio) (State)
River/Stream 0.8 mi193 mg/L52005–2007
CUYAHOGA R. DST. KENT, 0.8 MILES UPST. MIDDLEBURY RD.
Division of Surface water (Ohio) (State)
River/Stream 0.9 mi202 mg/L62007
CUYAHOGA R. @ STANDING ROCK CEMETERY (FREE FLOWING)
Division of Surface water (Ohio) (State)
River/Stream 1.3 mi148 mg/L72005–2019
FISH CREEK @ SPAULDING DRIVE
Division of Surface water (Ohio) (State)
River/Stream 1.4 mi374 mg/L62000

Water hardness in towns near Kent

TownDistanceMedianClass
Tallmadge4 mi 238 mg/LVery hard
Stow4 mi 233 mg/LVery hard
Ravenna6 mi 209 mg/LVery hard
Streetsboro6 mi 204 mg/LVery hard
Hudson8 mi 223 mg/LVery hard
Akron10 mi 236 mg/LVery hard
Cuyahoga Falls10 mi 229 mg/LVery hard
Aurora11 mi 198 mg/LVery hard
Twinsburg13 mi 222 mg/LVery hard
Macedonia14 mi 224 mg/LVery hard

Portage County

Kent is in Portage County, where the median is 221 mg/L (very hard) across 104 sites.

See all of Portage County →

Ohio

The statewide median is 276 mg/L (very hard) from 6,849 sites.

Ohio hardness map →

Kent, OH water: common questions

Do I need a water softener in Kent?

Very likely. Water measured around Kent is 12.3 gpg (211 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 22,000 grains.Size it for your household →

Who supplies Kent's drinking water?

The main public water system serving Kent in EPA records is Kent City PWS. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Kent?

It depends on what you want to remove. In Kent, the system reports 1 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next