Water hardness in Plainview, NY
Water in Plainview is soft, with a median of 46 mg/L (2.7 grains per gallon) across 39 monitoring sites within 10 miles.
Plainview tap water at a glance
- HardnessSoft (46 mg/L, 2.7 gpg, local measurements). A water softener isn't needed.Water heater care →
- PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesNo lead service lines reported.Details →
- Violations2 health-based violations since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 46 mg/L means at home
- Water softener: A water softener is generally not needed. Soft water rarely causes scale.
- Dishwasher: set the water hardness to about 2.7 gpg (2.6 °dH), which is the lowest hardness setting (or softener off).
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Plainview
Prefilled with Plainview's measured local hardness of 46 mg/L (2.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Plainview tap water
Plainview WD is the main public water system for Plainview. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 10 samples taken May 2024 – Nov 2024. 1 PFAS was detected.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFBA perfluorobutanoic acid | 10.9 ppt | 3 of 10 samples | — |
Other water systems serving parts of Plainview
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Bethpage WD serves over 10,000 people | PFBA, PFPeA, PFHxA +1 more | — | Jan 2023 – Jul 2023 |
| Jericho WD serves over 10,000 people | PFBA, PFPeA, PFHxA +2 more | — | Apr 2023 – Nov 2025 |
| South Farmingdale WD serves over 10,000 people | None detected | — | Jun 2023 – Jul 2024 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Plainview
Plainview WD reported 10,743 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.
Other water systems serving parts of Plainview
| Water system | Service lines | Total |
|---|---|---|
| Bethpage WD | 27 lead · 10 galvanized · 61 unknown | 8,720 |
| Jericho WD | 2 lead · 3 galvanized · 73 unknown | 19,246 |
| South Farmingdale WD | 2 lead · 4 galvanized · 325 unknown | 12,664 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Plainview drinking water violations
EPA records show 2 health-based violations for Plainview WD since 2016, all since resolved or closed. The most recent began in Jul 2017.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Tetrachloroethylene (PCE) an industrial and dry-cleaning solvent highest measured 7.9 UG/L; limit 0.005 mg/L | Contaminant above legal limit | 1 | Jul 2017 | Resolved/closed |
| cis-1,2-Dichloroethylene highest measured 6 UG/L; limit 0.07 mg/L | Contaminant above legal limit | 1 | Jul 2017 | Resolved/closed |
Other water systems serving parts of Plainview
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Bethpage WD | None | 0 |
| Jericho WD | 1 | 0 |
| South Farmingdale WD | None | 0 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Plainview
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| N 12670. 1 USGS New York Water Science Center | Well | 1.5 mi | 9 mg/L | 1 | 2016 |
| N 6644. 1 USGS New York Water Science Center | Well | 3.4 mi | 20 mg/L | 1 | 2016 |
| S 16874. 3 USGS New York Water Science Center | Well | 3.9 mi | 47 mg/L | 4 | 2006–2018 |
| N 9923. 1 USGS New York Water Science Center | Well | 4.1 mi | 62 mg/L | 1 | 2018 |
| S 20601. 1 USGS New York Water Science Center | Well | 4.8 mi | 32 mg/L | 1 | 2012 |
| N 11850. 1 USGS New York Water Science Center | Well | 5.2 mi | 94 mg/L | 4 | 2006–2018 |
Water hardness in towns near Plainview
| Town | Distance | Median | Class |
|---|---|---|---|
| Bethpage | 2 mi | 47 mg/L | Soft |
| Syosset | 3 mi | 44 mg/L | Soft |
| Hicksville | 3 mi | 49 mg/L | Soft |
| Melville | 3 mi | 32 mg/L | Soft |
| Jericho | 4 mi | 46 mg/L | Soft |
| Levittown | 4 mi | 49 mg/L | Soft |
| South Farmingdale | 5 mi | 47 mg/L | Soft |
| New Cassel | 5 mi | 47 mg/L | Soft |
| Salisbury | 5 mi | 46 mg/L | Soft |
| North Massapequa | 5 mi | 49 mg/L | Soft |
Nassau County
Plainview is in Nassau County, where the median is 50 mg/L (soft) across 47 sites.
See all of Nassau County →New York
The statewide median is 77 mg/L (moderately hard) from 2,847 sites.
New York hardness map →Plainview, NY water: common questions
Do I need a water softener in Plainview?
Probably not. Water measured around Plainview is 2.7 gpg (46 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable.When a softener helps →
Who supplies Plainview's drinking water?
The main public water system serving Plainview in EPA records is Plainview WD. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Plainview?
It depends on what you want to remove. In Plainview, EPA testing found PFBA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system had 2 health-based violations since 2016, for Tetrachloroethylene and cis-1,2-Dichloroethylene; the utility's annual report says what was done about them. On the other hand, no lead service lines reported. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Which water filters remove PFAS?EPA tests found 1 PFAS in Plainview's main water system.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.