Water hardness in Washington, MO
Water in Washington is moderately hard, with a median of 114 mg/L (6.7 grains per gallon) across 7 monitoring sites within 10 miles.
Washington tap water at a glance
- HardnessModerately hard (114 mg/L, 6.7 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- PFASNone found in EPA's nationwide testing of the main water system.PFAS results →
- Lead pipesNo known lead lines; 11 lines are still of unknown material.Check your own pipe →
- Violations1 health-based violation since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 114 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 6.7 gpg (6.4 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Washington
Prefilled with Washington's measured local hardness of 114 mg/L (6.7 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Washington tap water
Washington PWS is the main public water system for Washington. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 19 samples taken Jun 2024 – Dec 2024. No PFAS were found at or above EPA's minimum reporting levels.
Other water systems serving parts of Washington
| Water system | PFAS detected | Highest PFOA / PFOS | Tested |
|---|---|---|---|
| Thomas Hill PWSD 1 serves over 10,000 people | PFBA | — | Apr 2024 – Oct 2025 |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Washington
Washington PWS reported 7,043 service lines (the pipes connecting homes to the water main) in its inventory. It reported no known lead lines, but 11 lines are still of unknown material.
Other water systems serving parts of Washington
| Water system | Service lines | Total |
|---|---|---|
| Thomas Hill PWSD 1 | 0 lead · 0 galvanized · 2,653 unknown | 4,523 |
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Washington drinking water violations
EPA records show 1 health-based violation for Washington PWS since 2016, all since resolved or closed. The most recent began in Jul 2024. It also had 4 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Groundwater Rule requirements to protect well water from fecal contamination | Treatment requirement not met | 1 | Jul 2024 | Resolved/closed |
Other water systems serving parts of Washington
| Water system | Health-based violations | Monitoring/reporting |
|---|---|---|
| Thomas Hill PWSD 1 | None | 3 |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Washington
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| Bourbeuse R. nr. N. Prairie Dell Rd. US of RR tracks Missouri Dept. of Natural Resources | River/Stream | 7.4 mi | 111 mg/L | 4 | 2021 |
| Bourbeuse R. @ HWY 50 Missouri Dept. of Natural Resources | River/Stream | 7.5 mi | 112 mg/L | 4 | 2021 |
| Bourbeuse R. abv Unnamed trib. bl. Hwy 50 Missouri Dept. of Natural Resources | River/Stream | 7.8 mi | 114 mg/L | 6 | 2021 |
| Bourbeuse River above Union, MO USGS Missouri Water Science Center | Stream | 8.3 mi | 125 mg/L | 63 | 2000–2023 |
| Bourbeuse R. 1.7 mi bl. Hwy 50 Missouri Dept. of Natural Resources | River/Stream | 8.3 mi | 114 mg/L | 5 | 2021 |
| Charrette Cr. @ Hwy 47 Missouri Dept. of Natural Resources | River/Stream | 8.8 mi | 189 mg/L | 41 | 2007–2013 |
Water hardness in towns near Washington
| Town | Distance | Median | Class |
|---|---|---|---|
| Union | 8 mi | 114 mg/L | Moderately hard |
| Wildwood | 19 mi | 242 mg/L | Very hard |
| Wentzville | 20 mi | 209 mg/L | Very hard |
| Lake St. Louis | 20 mi | 208 mg/L | Very hard |
| Eureka | 20 mi | 239 mg/L | Very hard |
| Dardenne Prairie | 21 mi | 216 mg/L | Very hard |
| O'Fallon | 23 mi | 213 mg/L | Very hard |
| Chesterfield | 25 mi | 262 mg/L | Very hard |
| Ballwin | 25 mi | 274 mg/L | Very hard |
| St. Peters | 27 mi | 270 mg/L | Very hard |
Franklin County
Washington is in Franklin County, where the median is 248 mg/L (very hard) across 31 sites.
See all of Franklin County →Washington, MO water: common questions
Do I need a water softener in Washington?
Probably not. Water measured around Washington is 6.7 gpg (114 mg/L, measured locally), under the 7 gpg (120 mg/L) level where scale on fixtures and appliances becomes noticeable. If spotting bothers you, about 12,000 grains of capacity covers a 3-person home between weekly regenerations.Size it for your household →
Who supplies Washington's drinking water?
The main public water system serving Washington in EPA records is Washington PWS. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Washington?
It depends on what you want to remove. In Washington, the system had 1 health-based violation since 2016, for the Groundwater Rule; the utility's annual report says what was done about it. On the other hand, no PFAS found in EPA testing and no lead service lines reported. A water softener is not a filter.How to read your water quality report →
Hardness scale
What to read next
- How to tell if your home has a lead pipe11 service lines here are of unknown material.
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.