Water hardness in Baltimore, MD
Water in Baltimore is very hard, with a median of 266 mg/L (15.5 grains per gallon) across 101 monitoring sites within 10 miles.
Large city utilities sometimes soften, blend or import water from distant reservoirs, so tap water in Baltimore can differ from local source water. Your utility's annual Consumer Confidence Report lists the exact tap value.
Baltimore tap water at a glance
- HardnessVery hard (266 mg/L, 15.5 gpg, local measurements). Water softeners are common at this level.Size a water softener →
- PFAS1 found in EPA testing; every result with a federal limit was at or below it.PFAS results →
- Lead pipesThe water system reported 47 lead service lines.Check your own pipe →
- Violations4 health-based violations since 2016.What they were →
Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?
What 266 mg/L means at home
- Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
- Dishwasher: set the water hardness to about 15.5 gpg (14.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
- Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
- Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
- Water heater: flush the tank once a year to clear sediment and scale.
Size a softener for your home → Hard water and your water heater →
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Baltimore
Prefilled with Baltimore's measured local hardness of 266 mg/L (15.6 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
PFAS in Baltimore tap water
City of Baltimore is the main public water system for Baltimore. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 12 samples taken Aug 2024 – May 2025. 1 PFAS was detected.
| Chemical | Highest result | Detected in | EPA limit |
|---|---|---|---|
| PFPeA perfluoropentanoic acid | 3 ppt | 1 of 12 samples | — |
What these PFAS levels mean → Which water filters remove PFAS →
Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology
Lead pipes in Baltimore
City of Baltimore reported 336,126 service lines (the pipes connecting homes to the water main) in its inventory. 47 are lead and 385 are galvanized lines that must be replaced, and 335,694 are still of unknown material.
EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask City of Baltimore whether your address is on its list.
How to tell if your home has a lead pipe → Lead pipes in every state →
As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology
Baltimore drinking water violations
EPA records show 4 health-based violations for City of Baltimore since 2016, all since resolved or closed. The most recent began in Apr 2026. It also had 7 monitoring or reporting violations (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.
| Contaminant or rule | Type | Violations | Most recent | Status |
|---|---|---|---|---|
| Total trihalomethanes (TTHM) byproducts formed when chlorine reacts with natural matter in water · what it means highest measured 83 UG/L; limit 0.080 mg/L | Contaminant above legal limit | 2 | Apr 2026 | Resolved/closed |
| Coliform bacteria / E. coli (Revised Total Coliform Rule) bacteria that signal possible contamination of the system · what it means | Contaminant above legal limit | 1 | Sep 2022 | Resolved/closed |
| Haloacetic acids (HAA5) byproducts of chlorine disinfection · what it means highest measured 63 UG/L; limit 0.060 mg/L | Contaminant above legal limit | 1 | Jan 2016 | Resolved/closed |
Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology
Monitoring sites closest to Baltimore
| Site | Type | Distance | Median | Samples | Years |
|---|---|---|---|---|---|
| 3S2E- 5 USGS Maryland Water Science Center | Well | 2.5 mi | 402 mg/L | 1 | 2003 |
| GWYNNS FALLS AT WASHINGTON BLVD AT BALTIMORE, MD USGS Maryland Water Science Center | Stream | 2.9 mi | 130 mg/L | 1 | 2000 |
| PATAPSCO RIVER TRIBUTARY AT HALETHORPE, MD USGS Maryland Water Science Center | Stream | 5.5 mi | 145 mg/L | 1 | 2000 |
| BA Ff 92 USGS Maryland Water Science Center | Well | 6.6 mi | 124 mg/L | 1 | 2003 |
| UNNAMED TRIB TO PATAPSCO RIVER NEAR PATAPSCO, MD USGS Maryland Water Science Center | Stream | 6.7 mi | 95 mg/L | 1 | 2000 |
| BA Ee 230 USGS Maryland Water Science Center | Well | 7.3 mi | 202 mg/L | 1 | 2004 |
Water hardness in towns near Baltimore
| Town | Distance | Median | Class |
|---|---|---|---|
| Brooklyn Park | 6 mi | 73 mg/L | Moderately hard |
| Rosedale | 6 mi | 265 mg/L | Very hard |
| Arbutus | 6 mi | 55 mg/L | Soft |
| Dundalk | 7 mi | 138 mg/L | Hard |
| Towson | 7 mi | 244 mg/L | Very hard |
| Parkville | 7 mi | 258 mg/L | Very hard |
| Overlea | 7 mi | 262 mg/L | Very hard |
| Linthicum | 7 mi | 39 mg/L | Soft |
| Lochearn | 7 mi | 138 mg/L | Hard |
| Woodlawn | 7 mi | 103 mg/L | Moderately hard |
Baltimore city
Baltimore is in Baltimore city, where the median is 266 mg/L (very hard) across 2 sites.
See all of Baltimore city →Baltimore, MD water: common questions
Do I need a water softener in Baltimore?
Very likely. Water measured around Baltimore is 15.5 gpg (266 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 27,000 grains.Size it for your household →
Who supplies Baltimore's drinking water?
The main public water system serving Baltimore in EPA records is City of Baltimore. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →
Do I need a water filter in Baltimore?
It depends on what you want to remove. In Baltimore, EPA testing found PFPeA in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system reports 47 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced; the system had 4 health-based violations since 2016, for TTHM and the Revised Total Coliform Rule and more; the utility's annual report says what was done about them. A water softener is not a filter.Filters that remove PFAS →
Hardness scale
What to read next
- Do you need a water softener?Water here is very hard; size a softener with our calculator.
- Which water filters remove PFAS?EPA tests found 1 PFAS in Baltimore's main water system.
- How to tell if your home has a lead pipe47 lead service lines are reported here.
- TTHM in drinking waterDisinfection byproducts appear in this system's violation record.