Water hardness in Morris, IL

Water in Morris is very hard, with a median of 304 mg/L (17.8 grains per gallon) across 9 monitoring sites within 10 miles.

about the same as the Illinois median (293 mg/L) 81st hardest of 225 Illinois towns Population 14,508
304mg/L
17.8 grains per gallon
Very hard

Morris tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 304 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 17.8 gpg (17 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites9
Lab samples65
Sample years2000–2023
Middle 50% of sites217–331 mg/L
Groundwater (wells, springs)349 mg/L · 2 sites
Surface water (rivers, lakes)237 mg/L · 7 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Morris

Prefilled with Morris's measured local hardness of 304 mg/L (17.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Morris tap water

The City of Morris water system is the main public water system for Morris. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 2 samples taken Nov 2023 – May 2024. No PFAS were found at or above EPA's minimum reporting levels.

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Morris

The City of Morris water system reported 5,455 service lines (the pipes connecting homes to the water main) in its inventory. 1,435 are lead and 12 are galvanized lines that must be replaced, and 182 are still of unknown material.

1,435lead (26%)
12galvanized requiring replacement
182unknown material (3%)
3,826not lead (70%)

EPA's 2024 lead rule requires most water systems to replace these lines within 10 years, starting in November 2027 (the rule is being challenged in court). Ask the City of Morris water system whether your address is on its list.

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Morris drinking water violations

EPA records show no health-based violations for the City of Morris water system since 2016. It also had 1 monitoring or reporting violation (a required test or report was missed or late), which on their own do not mean the water exceeded a limit.

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Morris

SiteTypeDistanceMedianSamplesYears
33N7E-4.6c1
USGS Illinois Water Science Center
Well 1.4 mi310 mg/L22007–2017
Aux Sable Creek
illinois epa (State)
River/Stream 4.7 mi352 mg/L252000–2002
Illinois River
illinois epa (State)
River/Stream 7.1 mi207 mg/L12000
Mazon River
illinois epa (State)
River/Stream 7.3 mi331 mg/L232000–2002
MAZON RIVER NEAR COAL CITY, IL
USGS Illinois Water Science Center
Stream 7.3 mi237 mg/L92010
Johnny Run
illinois epa (State)
River/Stream 7.7 mi304 mg/L12001

Water hardness in towns near Morris

TownDistanceMedianClass
Minooka9 mi 268 mg/LVery hard
Channahon9 mi 240 mg/LVery hard
Shorewood14 mi 244 mg/LVery hard
Joliet17 mi 248 mg/LVery hard
Yorkville19 mi 344 mg/LVery hard
Plainfield20 mi 307 mg/LVery hard
Ottawa21 mi 304 mg/LVery hard
Crest Hill21 mi 255 mg/LVery hard
Oswego21 mi 318 mg/LVery hard
Plano22 mi 363 mg/LVery hard

Grundy County

Morris is in Grundy County, where the median is 304 mg/L (very hard) across 9 sites.

See all of Grundy County →

Illinois

The statewide median is 293 mg/L (very hard) from 1,100 sites.

Illinois hardness map →

Morris, IL water: common questions

Do I need a water softener in Morris?

Very likely. Water measured around Morris is 17.8 gpg (304 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 31,000 grains.Size it for your household →

Who supplies Morris's drinking water?

The main public water system serving Morris in EPA records is Morris. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Morris?

It depends on what you want to remove. In Morris, the system reports 1,435 lead service lines; if your home has one, a filter certified to remove lead is the usual step until the line is replaced. On the other hand, no PFAS found in EPA testing and no health-based violations since 2016. A water softener is not a filter.Check your own service line →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next