Water hardness in Summit County, CO
Water in Summit County is moderately hard, with a median of 90 mg/L (5.3 grains per gallon) across 243 monitoring sites.
Summit County water at a glance
- HardnessModerately hard (90 mg/L, 5.3 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
- Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →
What 90 mg/L means at home
- Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
- Dishwasher: set the water hardness to about 5.3 gpg (5 °dH), which is a low-to-medium hardness setting.
- Kettles and coffee makers: descaling every 3–6 months is usually enough.
- Laundry and soap: soap lathers easily and detergent goes further.
- Water heater: routine flushing every 2–3 years is typically fine.
Where the number comes from
Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it
Water softener and dishwasher calculator for Summit County
Prefilled with Summit County's measured local hardness of 90 mg/L (5.3 gpg). If your water bill or utility report gives a different number, enter it instead.
Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter
Summit County on the Colorado map
Cities and communities in Summit County
| Place | Median mg/L | Class | Based on |
|---|---|---|---|
| Breckenridge | 88 | Moderately hard | 152 sites within 10 miles |
| Silverthorne | 76 | Moderately hard | 51 sites within 10 miles |
| Frisco | 88 | Moderately hard | 147 sites within 10 miles |
| Keystone (CDP) | 88 | Moderately hard | 241 sites within 10 miles |
| Dillon | 83 | Moderately hard | 92 sites within 10 miles |
| Blue River | 90 | Moderately hard | 135 sites within 10 miles |
| Copper Mountain (CDP) | 90 | Moderately hard | 139 sites within 10 miles |
| Heeney (CDP) | 88 | Moderately hard | 16 sites within 10 miles |
| Montezuma | 64 | Moderately hard | 216 sites within 10 miles |
Water quality in Summit County communities
Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology
| Community | Water system | PFAS | Lead lines | Violations |
|---|---|---|---|---|
| Breckenridge | Town of Breckenridge | None detected | 0 lead · 0 unknown | 2 |
| Silverthorne | Town of Silverthorne | 2 found | 0 lead · 0 unknown | None |
| Frisco | Town of Frisco | None detected | 0 lead · 37 unknown | 1 |
| Dillon | Town of Dillon | Not tested | 0 lead · 0 unknown | None |
| Heeney | Heeney Water District | Not tested | 0 lead · 0 unknown | None |
Neighboring counties
- Clear Creek County68 mg/L
- Eagle County167 mg/L
- Lake County106 mg/L
- Grand County41 mg/L
- Gilpin County88 mg/L
- Park County138 mg/L
Hardness scale
What to read next
- Water hardness converterConvert mg/L to grains per gallon or °dH for your dishwasher.
- How to test your well waterFor homes on private wells, which local data doesn't cover.