Water hardness in Denver County, CO

Water in Denver County is very hard, with a median of 278 mg/L (16.3 grains per gallon) across 62 monitoring sites.

104% harder than the Colorado median (136 mg/L) 18th hardest of 62 counties
278mg/L
16.3 grains per gallon
Very hard

Denver County water at a glance

  • HardnessVery hard (278 mg/L, 16.3 gpg, local measurements). Water softeners are common at this level.Size a water softener →
  • Private wellsWells aren't covered by public water rules; test yearly for bacteria and nitrate.Well testing →

What 278 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 16.3 gpg (15.6 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites62
Lab samples1,406
Sample years2000–2026
Middle 50% of sites200–344 mg/L
Groundwater (wells, springs)1125 mg/L · 4 sites
Surface water (rivers, lakes)273 mg/L · 58 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Denver County

Prefilled with Denver County's measured local hardness of 278 mg/L (16.3 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Denver County on the Colorado map

Kit Carson CountyRio Grande CountyMineral CountyWashington CountyYuma CountyMontrose CountyAdams CountyArapahoe CountyGilpin CountyLincoln CountyPhillips CountyElbert CountyAlamosa CountyMoffat CountyTeller CountyMorgan CountyCrowley CountyDelta CountyLake CountyProwers CountyLarimer CountyChaffee CountyOuray CountyMontezuma CountyGarfield CountyBaca CountyJackson CountyFremont CountyHinsdale CountyCostilla CountyConejos CountyLa Plata CountyArchuleta CountyCheyenne CountyJefferson CountyClear Creek CountySummit CountyPitkin CountySan Juan CountySan Miguel CountySedgwick CountyBent CountyWeld CountyBoulder CountyRoutt CountyEagle CountyGunnison CountyRio Blanco CountyPueblo CountyLas Animas CountyPark CountyDouglas CountyDolores CountyGrand CountyMesa CountyCuster CountyBroomfield CountyHuerfano CountyEl Paso CountyKiowa CountySaguache CountyLogan CountyOtero County

Cities and communities in Denver County

PlaceMedian mg/LClassBased on
Denver 105 Moderately hard 225 sites within 10 miles

Water quality in Denver County communities

Each community's public water system as listed by EPA: PFAS (EPA UCMR 5), lead service lines (EPA inventory) and health-based violations since 2016. Methodology

CommunityWater systemPFASLead linesViolations
Denver Denver Water Board None detected 15,826 lead · 34,057 unknown None

Neighboring counties

Colorado

The statewide median is 136 mg/L (hard) from 8,191 sites.

Colorado hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next