Water hardness in Gilroy, CA

Water in Gilroy is very hard, with a median of 230 mg/L (13.4 grains per gallon) across 43 monitoring sites within 10 miles.

46% harder than the California median (158 mg/L) 201st hardest of 484 California towns Population 58,250
230mg/L
13.4 grains per gallon
Very hard

Gilroy tap water at a glance

Choosing a filter? Whole-house vs under-sink · Reverse osmosis · Hot or cold tap water?

What 230 mg/L means at home

  • Water softener: Scale build-up is likely. A water softener is commonly used to protect plumbing, water heaters and appliances.
  • Dishwasher: set the water hardness to about 13.4 gpg (12.9 °dH), which is a high or maximum hardness setting, with dishwasher salt if your model takes it.
  • Kettles and coffee makers: descale every 1–2 months with citric acid or vinegar.
  • Laundry and soap: hard water reduces lather, so you may need more detergent, or a softener.
  • Water heater: flush the tank once a year to clear sediment and scale.

Where the number comes from

Monitoring sites43
Lab samples90
Sample years2005–2022
Middle 50% of sites206–358 mg/L
Groundwater (wells, springs)244 mg/L · 35 sites
Surface water (rivers, lakes)212 mg/L · 8 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Water Quality Portal (USGS, EPA and state agencies). Utilities that soften or blend water may deliver different numbers, so check your utility's Consumer Confidence Report for exact tap values. Methodology · On a private well? How to test it

Water softener and dishwasher calculator for Gilroy

Prefilled with Gilroy's measured local hardness of 230 mg/L (13.5 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Softener sizes assume the EPA average of 82 gallons per person per day; sodium uses about 8 mg/L added per grain removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

PFAS in Gilroy tap water

City of Gilroy is the main public water system for Gilroy. EPA's nationwide UCMR 5 study tested it for 29 PFAS ("forever chemicals") in 14 samples taken Dec 2024 – Jul 2025. 7 PFAS were detected. The highest PFOA and PFOS results were above EPA's drinking water limit (4 ppt).

ChemicalHighest resultDetected inEPA limit
PFBS
perfluorobutane sulfonic acid
9.4 ppt 5 of 14 samples —
PFOA
perfluorooctanoic acid
8 ppt 6 of 14 samples 4 ppt
PFPeA
perfluoropentanoic acid
7.8 ppt 5 of 14 samples —
PFHxA
perfluorohexanoic acid
7 ppt 6 of 14 samples —
PFOS
perfluorooctane sulfonic acid
5.8 ppt 1 of 14 samples 4 ppt
PFHpA
perfluoroheptanoic acid
3.6 ppt 1 of 14 samples —
PFHxS
perfluorohexane sulfonic acid
3.5 ppt 1 of 14 samples 10 ppt*

What these PFAS levels mean → Which water filters remove PFAS →

Highest single sample in parts per trillion (ppt). Limits apply to yearly averages from 2029, so one high sample is not a violation. *Limit proposed for withdrawal in 2026. ND = not detected. PFAS results for every state · Source: EPA UCMR 5 · Methodology

Lead pipes in Gilroy

City of Gilroy reported 15,788 service lines (the pipes connecting homes to the water main) in its inventory. It reported no lead or galvanized lines requiring replacement.

0lead (0%)
0galvanized requiring replacement
0unknown material (0%)
15,788not lead (100%)

How to tell if your home has a lead pipe → Lead pipes in every state →

As reported to EPA (first quarter of 2026). Unknown lines may or may not contain lead; numbers change as utilities inspect lines. Sources: EPA service line inventory · EPA Lead and Copper Rule Improvements · Methodology

Gilroy drinking water violations

EPA records show 1 health-based violation for City of Gilroy since 2016, all since resolved or closed. The most recent began in Jun 2022.

Contaminant or ruleTypeViolationsMost recentStatus
Nitrate
from fertilizer, septic systems and manure · what it means
highest measured 12 MG/L; limit 10 mg/L
Contaminant above legal limit 1 Jun 2022 Resolved/closed

Violations since January 2016, EPA records (2026Q3). A violation is not the same as illness; your utility's annual water quality report explains each one. Violations in every state · Source: EPA ECHO / SDWIS · Methodology

Monitoring sites closest to Gilroy

SiteTypeDistanceMedianSamplesYears
UVAS C A MILLER AVE A GILROY CA
USGS California Water Science Center
Stream 0.6 mi154 mg/L62017
011S004E05C001M
USGS California Water Science Center
Well 1.7 mi254 mg/L32008–2018
011S004E05C002M
USGS California Water Science Center
Well 1.7 mi157 mg/L12008
010S004E32E006M
USGS California Water Science Center
Well 1.7 mi227 mg/L12008
010S004E32E005M
USGS California Water Science Center
Well 1.7 mi205 mg/L12008
010S004E32E004M
USGS California Water Science Center
Well 1.7 mi169 mg/L12008

Water hardness in towns near Gilroy

TownDistanceMedianClass
Morgan Hill9 mi 228 mg/LVery hard
Watsonville12 mi 204 mg/LVery hard
Prunedale14 mi 302 mg/LVery hard
Hollister15 mi 324 mg/LVery hard
Live Oak22 mi 200 mg/LVery hard
Salinas22 mi 240 mg/LVery hard
San Jose24 mi 265 mg/LVery hard
Scotts Valley24 mi 194 mg/LVery hard
Santa Cruz25 mi 216 mg/LVery hard
Marina25 mi 231 mg/LVery hard

Santa Clara County

Gilroy is in Santa Clara County, where the median is 250 mg/L (very hard) across 78 sites.

See all of Santa Clara County →

California

The statewide median is 158 mg/L (hard) from 5,772 sites.

California hardness map →

Gilroy, CA water: common questions

Do I need a water softener in Gilroy?

Very likely. Water measured around Gilroy is 13.4 gpg (230 mg/L, measured locally), above 10.5 gpg (180 mg/L), where softeners are common. For a 3-person home that regenerates weekly, that means a softener of about 24,000 grains.Size it for your household →

Who supplies Gilroy's drinking water?

The main public water system serving Gilroy in EPA records is City of Gilroy. Some neighborhoods may be served by a different system, so check the name on your water bill.How we match towns to water systems →

Do I need a water filter in Gilroy?

It depends on what you want to remove. In Gilroy, EPA testing found PFBS, PFOA and PFPeA and 4 other PFAS in the main system; filters certified to NSF/ANSI 53 or 58 for PFOA and PFOS reduction can lower PFAS; the system had 1 health-based violation since 2016, for Nitrate; the utility's annual report says what was done about it. On the other hand, no lead service lines reported. A water softener is not a filter.Filters that remove PFAS →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next