Water hardness in Kent, BC

Water in Kent is moderately hard, with a median of 100 mg/L (5.8 grains per gallon) across Fraser Valley Region.

54% harder than the British Columbia median (65 mg/L) 28th hardest of 99 British Columbia municipalitys Population 6,300
100mg/L
5.8 grains per gallon
Moderately hard

There are not enough monitoring sites within 25 km of Kent, so this page uses the Fraser Valley Region median.

Kent tap water at a glance

  • HardnessModerately hard (100 mg/L, 5.8 gpg, local measurements). Some scale; descale kettles and flush the water heater.Water heater care →
  • GuidelinesHealth Canada's lead guideline is 5 µg/L; there is no guideline for hardness.Canadian guidelines →

What 100 mg/L means at home

  • Water softener: Most homes do not need a softener. You may notice light spotting on glass and fixtures.
  • Dishwasher: set the water hardness to about 5.8 gpg (5.6 °dH), which is a low-to-medium hardness setting.
  • Kettles and coffee makers: descaling every 3–6 months is usually enough.
  • Laundry and soap: soap lathers easily and detergent goes further.
  • Water heater: routine flushing every 2–3 years is typically fine.

Where the number comes from

Monitoring sites2
Lab samples1,084
Sample years2000–2026
Middle 50% of sites80–120 mg/L
Surface water (rivers, lakes)100 mg/L · 2 sites

Measured hardness of local source water (mg/L as calcium carbonate) from Environment and Climate Change Canada and the Government of Ontario. Utilities that soften or blend water may deliver different numbers, so check your utility's annual drinking water quality report for exact tap values. Methodology

Water softener and dishwasher calculator for Kent

Prefilled with Kent's measured local hardness of 100 mg/L (5.8 gpg). If your water bill or utility report gives a different number, enter it instead.

Softener capacity needed (at least)–
Dishwasher setting–set your dishwasher's water hardness to this
Sodium added by softening–

Water use defaults to the Canadian average of 223 litres per person per day (Statistics Canada, 2021); softeners are rated in grains of hardness removed. Sodium uses about 8 mg/L added per grain per gallon removed (University of Nebraska–Lincoln). More: do you need a softener? · softener salt and sodium · hardness converter

Water hardness in towns near Kent

TownDistanceMedianClass
Chilliwack19 km 100 mg/LModerately hard
Hope26 km 100 mg/LModerately hard
Mission41 km 100 mg/LModerately hard
Abbotsford44 km 100 mg/LModerately hard
Maple Ridge54 km 26 mg/LSoft
Langley (District Municipality)61 km 26 mg/LSoft
Pitt Meadows64 km 26 mg/LSoft
Langley (City)67 km 26 mg/LSoft
Port Coquitlam72 km 26 mg/LSoft
Coquitlam72 km 26 mg/LSoft

Fraser Valley Region

Kent is in Fraser Valley Region, where the median is 100 mg/L (moderately hard) across 2 sites.

See all of Fraser Valley Region →

British Columbia

The statewide median is 65 mg/L (moderately hard) from 54 sites.

British Columbia hardness map →

Hardness scale

Soft0–60 mg/L0–3.5 gpg
Moderately hard61–120 mg/L3.5–7 gpg
Hard121–180 mg/L7–10.5 gpg
Very hardover 180 mg/Lover 10.5 gpg

What to read next