Why is my water heater leaking?

Updated November 21, 2026 · Based on EPA and other public sources listed below · How we make our content

Short answer: where the water comes from tells you the cause. Leaks at the top are usually loose inlet or outlet connections, at the side the temperature and pressure (T&P) relief valve, and at the bottom the drain valve or the tank itself. Connections and valves can be fixed; a corroded or cracked tank cannot and means a new heater, according to the manufacturer A. O. Smith.

First steps when you find a leak

  1. Turn off the energy: switch off the power at the breaker for an electric heater, or turn the gas control to off for a gas heater.
  2. Turn off the cold water supply valve on the pipe going into the heater.
  3. Find where the water comes from before you mop up: top, side or bottom. Dry the area and watch where it reappears.

Where it's leaking and what it means

WhereLikely causeUsual fix
TopLoose cold inlet or hot outlet connection, worn fittingTighten gently or replace the fitting (over-tightening can make it worse)
Side (pipe from the valve)T&P relief valve opening because of excessive temperature or pressure, or a faulty valveLower the thermostat, add an expansion tank or pressure-reducing valve, or replace the valve
Bottom, at the drain valveDrain valve not fully closed or faultyClose it or replace the valve
Bottom, from the tankCorrosion or a crack in the tankReplace the water heater (cannot be repaired)
Drops that come and goCondensation, often mistaken for a leakUsually no repair needed

Based on A. O. Smith's leak guide. The T&P relief valve is a safety device: if it keeps discharging, have a licensed plumber find out why.

Why tanks corrode, and how hard water plays a part

A. O. Smith names sediment and mineral buildup and a used-up anode rod among the causes of tank leaks. The anode is a metal rod that corrodes instead of the tank; the manufacturer says anode rods usually last 3 to 5 years and recommends flushing the tank once a year to remove sediment.

Hard water leaves more mineral scale in the tank. If your water is hard, flushing matters more: see hard water and your water heater, and check your town on the water hardness map.

Repair or replace?

Fix leaking connections and valves. Replace the heater if the tank itself leaks. If the heater is near the end of its life anyway, see how long a water heater lasts and, if you are thinking of going tankless, tankless heaters and hard water.

In Canada a tank heater is often called a hot water tank, in Australia a hot water system and in New Zealand a hot water cylinder; the leak points are the same.

Frequently asked questions

Why is my water heater leaking from the bottom?

A leak at the base can come from the drain valve or from the tank itself. A. O. Smith says corrosion and cracks in the tank cannot be repaired; a leaking tank means replacing the heater.

Why is my water heater leaking from the top?

Leaks at the top usually come from the cold inlet and hot outlet connections or fittings. Tighten them gently; A. O. Smith warns that over-tightening can make a leak worse.

Why is the pressure relief valve leaking?

A. O. Smith says leaks from the temperature and pressure (T&P) relief valve are often caused by excessive temperature or pressure. Lowering the thermostat, fitting an expansion tank or a pressure-reducing valve, or replacing a faulty valve are the usual fixes; have a professional check it.

Is condensation a leak?

Not necessarily. A. O. Smith notes condensation is often mistaken for a leak; on gas heaters it is typically temporary, for example when the tank fills with cold water.

Sources

Related guides